Aeg KS8100001M User Manual download pdf (Page 40)

12.5 Door and glass panels

Remove the door to clean it.

A

A

Removing the door

CAUTION!

Be careful when you remove the

door from the appliance. The

door is heavy.

1.

Open the door as far as it goes.

2.

Fully lift up the clamping levers (A)

on the two door hinges.

45°

3.

Close the door until it is at an angle

of approximately 45°.

4.

Hold the door with one hand on

each side and pull it away from the

appliance at an upwards angle.

Put the door with the outer side

down on a soft and level surface

to prevent scratches.

5.

At this time you can remove the in-

ner glass panels and clean them.

To install the door do the above steps in

the opposite sequence.

2

B

1

Removing and cleaning the door

glasses

The door has 2, 3 or 4 panels of

glass (the number depends on

the model).

CAUTION!

Rough handling of the glass, es-

pecially around the edges of the

front panel, can cause the glass

to break.

1.

Hold the door trim (B) on the top

edge of the door at the two sides

and push inwards to release the clip

seal.

2.

Pull the door trim to the front to re-

move it.

3.

Hold the door glass panels on their

top edges one by one and pull

them upwards from the guide.

4.

Clean the door glass panels.

To install the panels do the above

steps in the opposite sequence. In-

sert the smaller panel first, and then

the larger one.

40

www.aeg.com

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 51 52

Comments to this Manuals

No comments