AEG BS9354151M User Manual download pdf (Page 46)

• To clean metal surfaces, use a usual

cleaning agent.

• Clean the appliance interior after each

use. Then you can remove dirt more

easily and it does not burn on.

• Clean stubborn dirt with a special

oven cleaner.

• Clean all accessories after each use

and let them dry. Use a soft cloth with

warm water and a cleaning agent.

• If you have nonstick accessories, do

not clean them using aggressive

agents, sharp-edged objects or a dish-

washer. It can cause damage to the

nonstick coating.

12.1 Steam Cleaning

1.

Remove as much dirt as possible

manually.

CAUTION!

For a better performance you

should start the Steam Cleaning

function when the appliance is

cool. Check the residual heat.

Remove the shelf support to

clean the side walls.

2.

Put 400 ml of water mixed with 3 ta-

blespoons of vinegar directly into

the steam generator.

3.

Activate the Steam Cleaning func-

tion in the main menu. The duration

of the function is approximately 33

minutes.

4.

An acoustic signal sounds when the

programme is completed. Touch the

sensor field to deactivate the signal.

5.

Wipe the internal surface of the ap-

pliance with a soft sponge. You can

use warm water from the steam gen-

erator.

Do not use the sponge provided

with the appliance.

6.

Remove the remaining water from

the steam generator.

7.

After cleaning keep the appliance

door open for approximately 1 hour.

Wait until the appliance is dry.

You can get maximum effects of

the Steam Cleaning function if

you manually clean the appliance

immediately after the Steam

Cleaning function ends.

When the Steam Cleaning func-

tion is active, the lamp is off.

Always use the Steam Cleaning

function after cooking with

steam.

Use the Steam Cleaning function

two times if the level of dirt is

high. Make sure that the appli-

ance is cool before you activate

the second cycle.

12.2 Shelf supports

You can remove the shelf supports to

clean the side walls before activating the

Steam Cleaning function.

Removing the shelf supports

2

3

1

1.

Carefully pull the supports up and

out of the front catch.

2.

Lightly move the supports on the

front catch inwards.

3.

Pull the supports out of the rear

catch.

Installing the shelf supports

Install the shelf supports in the opposite

sequence.

12.3 Decalcification of the

Steam generator

1.

Put 250 ml of water mixed with 3 ta-

blespoons of vinegar directly into

the steam generator.

2.

Activate the Decalcification function

in the Assisted Cleaning menu. The

46

www.aeg.com

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 52

Comments to this Manuals

No comments