AEG NM 1600 Installation Manual download pdf (Page 21)

Illustration 4.4: Installed PV Power

Enter the amount of installed PV power for

each of the PV inputs. When two or more PV

inputs are connected in parallel, each PV in-

put in the parallel group must be set to the

total amount of PV power installed to that

group divided by the number of parallel in-

puts. See the table below for examples of in-

stalled PV power.

Illustration 4.5: Select Country

The display will now show “Select country”.

The country is set to “undefined” at initial

start-up. To select country press 'OK'. Press ‘

▼

’ to scroll down through the list of coun-

tries. Select the country in which the inverter

is installed by pressing ‘OK’. To meet medi-

um voltage grid requirements select a coun-

try option ending in MV. It is very important

that the correct country is chosen.

Illustration 4.6: Confirm Country Selection

Confirm the choice by selecting the country

again and press 'OK’. The settings for the

chosen country have now been activated.

The inverter only complies with local and national standards provided the correct

country has been selected. If a different country than the one the inverter is in-

stalled in is chosen it can have serious consequences.

4. Start-up and Check of Settings

20 8000038781_00_BAL_en / L00410564-01_02

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 32 33

No comments

AEG NM 1600 Installation Manual Page 21