AEG BPK842220M User Manual download pdf (Page 36)

4. Hold the door with one hand on each

side and pull it away from the oven at

an upwards angle.

5. Put the door with the outer side

down on a soft cloth on a stable

surface.

6. Hold the door trim (B) on the top

edge of the door at the two sides

and push inwards to release the clip

seal.

1

2

B

7. Pull the door trim to the front to

remove it.

8. Hold the door glass panels on their

top edge one by one and pull them

up out of the guide.

9. Clean the glass panel with water and

soap. Dry the glass panel carefully.

When the cleaning is completed, do the

above steps in the opposite sequence.

Install the smaller panel first, then the

larger and the door.

WARNING!

Make sure that the glasses

are inserted in the correct

position otherwise the

surface of the door may

overheat.

Make sure that you put the glass panels

(C, B and A) back in the correct

sequence. First, insert panel C, which has

a square printed on the left side and a

triangle on the right side. You will also

find those symbols embossed on the

door frame. The triangle symbol on the

glass must match the triangle on the

door frame, and the square symbol must

match the square. After that insert the

other two glass panels.

A B C

11.6 Replacing the lamp

WARNING!

Risk of electric shock.

The lamp can be hot.

1. Turn off the oven.

Wait until the oven is cooled down.

2. Disconnect the oven from the mains.

3. Put a cloth on the bottom of the

cavity.

The top lamp

1. Turn the lamp glass cover to remove

it.

2. Clean the glass cover.

3. Replace the lamp with a suitable 300

°C heat-resistant lamp.

4. Install the glass cover.

The side lamp

1. Remove the left shelf support to get

access to the lamp.

www.aeg.com

36

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 42 43 44

Comments to this Manuals

No comments