AEG SB4 series User Manual download pdf (Page 91)

100

101

Configuration

3.7.2 Mounting and Equipping the Subracks

Fix the subracks according to the module description

12)

. Dimension drawings can be

found in the module descriptions.

The following subracks are suitable for wall mounting:

DTA 101, DTA 102, DTA 103, DTA 107, DTA 112, DTA 113

All the subracks except for DTA 102 and DTA 112 are suitable for mounting in 19”

holders. Mounting flanges are required for DTA 101, DTA 103, DTA 107 and

DTA 113 (ordering code: 424 234 113).

Equip the subracks according to the pregiven configuration. Non-equipped slots in

the controller and in the DTA 025 subracks are to be closed with dummy strips.

Connect the modules according to the module descriptions

12)

(for the design of the

peripheral ports, see also section 3.2)

Caution All the modules of the c ontroller and with rear connection (PMB and

PEAB nodes) may only be disconnected or plugged in with t he supply switched

off.

Note Modules with front connections may only be disconnected or plugged in with the

supply switched on. The screw/plug-in terminals are to be removed before disconnect-

ing the modules and to be re-installed after they have been plugged in only. However,

the supply and working voltages of the affected modules should be switched off to

avoid short-circuits; the bus supply (via DEA 1x6) can remain switched on.

12) The module descriptions are included with the relevant modules. They are also combined

or the modules

of the controller in appendix B of this module, for the modules of the I/O periphery in the user manuals of

“Process peripheries with front connection” and “Process peripheries with rear connection”.

1 2 ... 86 87 88 89 90 91 92 93 94 95 96 ... 430 431

Comments to this Manuals

No comments

AEG SB4 series User Manual Page 91

Comments to this Manuals

Related products and manuals for Blenders AEG SB4 series