AEG NM 1714 Owner's Manual download pdf (Page 36)

32

qwer

Buttonhole

To adjust buttonhole stitch density:

Set the stitch length dial between “ “to

adjust the buttonhole stitch density.

q Pattern selector:

w Presser foot: Sliding buttonhole foot

e Thread tension: 1–5

r Stitch length:

(A)

(B)

(C)

z Carefully mark buttonhole length on fabric.

Place the fabric under the foot with the

buttonhole marking running toward you.

x Move the slider (A) toward you so that the top

mark (C) on the slider meets the start mark

(B). Line up the markings on the foot with the

top mark on the fabric.

Note:The scale on the slider is engraved in

centimeters.

c Set the pattern selector dial at “ ”.

Sew forward until you reach the front marking

of your buttonhole.

Stop sewing at a left stitch.

v Set the pattern selector dial at “ ”.

Sew 5 stitches. Stop sewing at a right stitch.

b Set the pattern selector dial at “ ”.

Sew until you reach the back marking of the

buttonhole.

Stop sewing at a right stitch.

n Set the pattern selector dial at “ ”.

Sew a few bartacks and raise the needle from

the fabric.

Set the pattern selector dial at a straight

stitch.

Sew a few locking stitches.

m Remove the fabric from the machine and cut

the sewing thread. Insert a pin inside the

bartack.

Then cut the opening with a seam ripper.

Take care not to cut the stitches.

z x

cvb

n

m

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 52 53

Comments to this Manuals

No comments