AEG AXP26V578HW User Manual download pdf (Page 17)

17

ENGLISH

Clean your air conditioner regularly to

keep it looking new.

Be sure to unplug the unit before cleaning

to prevent shock or re hazards.

Enter the context of your task here

(optional).

Be sure to unplug the air conditioner

to prevent shock or re hazard.

8.1 Air lter cleaning

8.2 Cabinet Cleaning

1.

Grasp the lters tab and pull o the

4 lters on the back of the unit one

by one.

2.

Wash the lter using liquid dishwashing

detergent and warm water. Rinse lter

thoroughly. Gently shake excess water

from the lter. Or, instead of washing

you may vacuum the lter clean.

3.

Put back the lter after the lter is dry.

Be sure lter is thoroughly dry

before replacing.

If you plan to store the appliance during

the winter, cover it with plastic or return

it to its carton box.

8.3 Winter Storage

•

Never use harsh cleaners, wax

or polish on the cabinet front.

•

Be sure to wring excess water from

the cloth before wiping around the

controls. Excess water in or around

the controls may cause damage

to the air conditioner.

Caution when cleaning the unit.

The cabinet and front may be dusted with

an oil-free cloth or washed with a cloth

dampened in a solution of warm water

and mild liquid dishwashing detergent.

Rinse thoroughly and wipe dry.

8.

CARE & CLEANING

9.

TROUBLE SHOOTING

Before calling for service, review this list.

It may save you time and expense. This

list includes common occurrences that are

not the result of defective workmanship

or materials in this appliance.

Air conditioner will not operate.

Air from unit does not feel cold

enough.

Air conditioner cooling, but room is

too warm - NO ice forming on cooling

coil behind decorative front.

•

Wall plug disconnected. Push plug

rmly into wall outlet.

•

House fuse blown or circuit breaker

tripped. Replace fuse with time delay

type or reset circuit breaker.

•

Control is OFF. Turn Control ON and

set to desired setting.

•

P1 appears in the display window.

Drain water as described in 7.3

Drainage Section.

•

Room Temperature lower than the set

temperature (Cool Mode). Reset the

temperature.

•

Room temperature below 16°C.

Cooling may not occur until room

temperature rises above 16°C.

•

Reset to a lower temperature.

•

Compressor shut-o by changing

modes. Wait approximately 3 minutes

and listen for compressor to restart

when set in the COOL mode.

•

Outdoor temperature below 16°C.

To defrost the coil, set Fan mode.

•

Air lter may be dirty. Clean lter.

Refer to 8. Care and Cleaning section.

To defrost, set to Fan mode.

•

Temperature is set too low for nighttime

cooling. To defrost the coil, set to Fan

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 95 96

Comments to this Manuals

No comments