AEG AXP26V578HW User Manual download pdf (Page 15)

15ENGLISH

After choosing the fan speed as

“Auto Fan”, “High”, “Mid” or “Low”,

the corresponding fan speed

indicator light will illuminate.

Under Auto and Dry mode, you

can not select the fan speed.

Dry mode DEACTIVATE WIFI MODULE:

Selecting fan speed

Auto mode

Always have the exhaust hose attached

in this mode.

When you set the air conditioner in Auto

mode, it will automatically select cooling,

heating (inapplicable for cooling only

models), or fan only operation depending

on what temperature you have selected

and the room temperature. The air

conditioner will control room temperature

automatically round the temperature

point set by you.

Under AUTO mode, you can not select

the fan speed.

1. Press the “Modes” button until the

“Auto mode” indicator lights.

After the “Auto mode” is selected the unit

will run automatically according to the

actual room air temperature.

In this mode you do not need to use the

exhaust adaptor hose, BUT the water

collected must be discharged. See 7.3

Drainage Section.

holding the “Connect button” and “ - ”

synchronously 3 seconds. Press the

“Connect button” again to activate the

10 seconds for the module to initiate again.

If the display reads “A5”, the room

temperature sensor has failed. Contact

your Authorized AEG Service Centre.

If the display reads “E5”, the evaporator

temperature sensor has failed. Contact

your Authorized AEG Service Centre.

If the display reads “E7”, the indoor motor

has failed. Contact your Authorized

AEG Service Center.

If the display reads “E4”, the display panel

communication has failed. Contact your

Authorized AEG Service Centre.

If the display reads “P1”, bottom tray is full.

Carefully move the unit to a drain location,

remove the bottom drain plug and let the

water drain away. Restart the machine

until the “P1” symbol disappears. If error

repeats, call for service.

You can select the desired fan speed, by

pressing the “Fan speed” button. The fan

speed will change in the sequence: “Auto

Fan”, “High”, “Mid”, “Low”.

7.2 Fault code

1.

Press the “Modes” button until the

“Dry” indicator is lit.

2.

The fan will run at low speed and

the display will show the room

temperature.

3.

Keep doors & windows closed

for

4.

Connected drain hose. See Drainage

section.

1.

2.

3

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 95 96

Comments to this Manuals

No comments