AEG BS836600SM User Manual download pdf (Page 57)

Remove the shelf support to clean the

side walls.

CAUTION!

For a better performance you

should start the cleaning

function when the appliance is

cool. Check the residual heat.

Always use the function after cooking

with steam.

When the function is active, the lamp is

off.

1. Put 400 ml of water mixed with 3

tablespoons of vinegar (without

herbs) directly into the steam

generator.

2. In the menu activate the function:

Steam Cleaning.

The display shows the duration of the

function (33 minutes).

An acoustic signal sounds when the

programme is completed.

3. Touch the display to deactivate the

signal.

4. Wipe the internal surface of the

appliance with a soft sponge.

5. Remove the remaining water from

the steam generator.

6. After cleaning keep the appliance

door open for approximately 1 hour.

Wait until the appliance is dry. To

speed up the drying you can heat up

the appliance with hot air at

temperature 150 °C for

approximately 15 minutes.

You can get maximum effects of the

cleaning function if you manually clean

the appliance immediately after the

function ends.

Use the function two times if the level of

dirt is high. Make sure that the appliance

is cool before you activate the second

cycle.

12.4 Decalcification of the

Steam generator

1. Put 250 ml of water mixed with 3

tablespoons of vinegar directly into

the steam generator.

2. In the menu choose: Assisted

Cleaning.

3. Activate the function: Decalcification.

The display shows the duration of the

function (15 minutes).

An acoustic signal sounds when the

programme is completed.

4. Touch a sensor field to deactivate

the signal.

5. Remove the remaining water from

the steam generator.

6. Keep the door open for

approximately 1 hour to let the

appliance dry fully. To speed up the

drying you can heat up the appliance

with hot air at temperature 150 °C for

approximately 15 minutes.

12.5 Removing and installing

the door

You can remove the door and the

internal glass panels to clean it. The

number of glass panels is different for

different models.

WARNING!

Be careful when you remove

the door from the appliance.

The door is heavy.

1. Open the door fully.

2. Fully press the clamping levers (A) on

the two door hinges.

A

A

3. Close the oven door to the first

opening position (approximately 70°

angle).

4. Hold the door with one hand on each

side and pull it away from the

appliance at an upwards angle.

5. Put the door with the outer side

down on a soft cloth on a stable

surface. This is to prevent scratches.

6. Hold the door trim (B) on the top

edge of the door at the two sides

and push inwards to release the clip

seal.

ENGLISH

57

1 2 ... 52 53 54 55 56 57 58 59 60

Comments to this Manuals

No comments