AEG 7200 Instruction Manual Page 22

  • Download
  • Add to my manuals
  • Print
  • Page
    / 60
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 21
22
EN
Preparing for playback
Input level adjustment (analog sources only)
If the input level of an analog source signal is too high, the "CLIP" indicator
will lights up. Adjust the input level.
1 Press the RCV MODE key on the remote control unit to
set it to the receiver control mode.
2 Press the SOUND key.
3 Use the MULTI CONTROL @ / # (or the @ / # keys) to select
"INPUT", and press the ENTER.
4 Use the MULTI CONTROL % / (or the % / keys) to
adjust the input level.
÷ The adjustment mode is displayed for approximately 20
seconds.
÷ The input level may be adjusted to any one of three settings:
0dB, -3dB, and -6dB. (The initial setting is 0dB.)
÷ You can store a separate input level for each input selector.
5 Press the SOUND key again to return to the input
indication.
Re-assignment of rear panel jacks
The assignment of the input selector positions to the digital audio and
component video input jacks can be changed as desired.
1 Press the SETUP key.
2 Use the MULTI CONTROL @/ # (or the @/ # keys) to
select "ASSIGN." on setup displays, and press the ENTER.
3 Use the MULTI CONTROL @/ # (or the @ / # keys) to
select "DIGITAL" or "COMPONENT", and press the ENTER.
1 "DIGITAL": Select to change the assignment of the digital
audio input jacks of the receiver.
2
"COMPONENT"
: Select to change the assignment of the
component video input jacks of the receiver.
3 "EXIT": Press the ENTER again to return to the main
setup displays.
Input selector position (%/)
1
"
DVD
"
2
"
V2
"
3
"
V1
"
4
"
AUX
"
When the "DIGITAL" has been selected:
Input selector position (%/)
1
"
DVD
"
2
"
V2
"
3
"
V1
"
Input jack selection (@/#)
1
"
CPNT1
"
2
"
CPNT2
"
When the "COMPONENT" has been selected:
Jack name
COAX2 (VIDEO 2)
OPT1 (VIDEO 1)
OPT2 (AUX)
COMPONENT VIDEO INPUT
IN1 (DVD)
COMPONENT VIDEO INPUT
IN2 (VIDEO 2)
COAX1 (DVD)
÷ It is not permitted to assign two input selector positions for
one input jack.
5 Repeat step 4 until you have assigned the desired jacks
to the desired input selector positions.
6 Press the ENTER again to return to the main setup
displays.
Use the following table for your memorandum.
Input jack Input selector
Assigned input selector
Input jack selection (@/#)
1
"
COAX1
"
2
"
COAX2
"
3
"
OPT1
"
4
"
OPT2
"
4 Press the MULTI CONTROL @/# (or the @/# keys) to select
the input jack name and then press the MULTI CONTROL
%/ (or the %/ keys) to select the input selector position.
Page view 21
1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 59 60

Comments to this Manuals

No comments