AEG 7200 Instruction Manual download pdf (Page 12)

Connecting the speakers

Setting up the system

SPEAKERS (6-8Ω)

FRONT

CENTER

SURR BACK / SW

R LSURR

Front Speakers

Surround Speakers

Be sure to connect both surround speakers

Surround Back Speaker

When the surround back speaker is

connected to these terminals, set

the speaker setting to

"BS/SW

BS".

)

In this case, the subwoofer should

be connected to the PRE OUT

SUBWOOFER jack. $

Subwoofer

When the subwoofer is connected

to these terminals, set the speaker

setting to

"BS/SW

)

In this case, two surround back

speakers should be connected to

the PRE OUT SURROUND BACK

jacks. $

Center

Speaker

LeftRight

Left

Right

Whether each speaker is connected properly can be

confirmed by outputting the test tone and checking if

each speaker channel outputs audio. For details, see

"Speaker settings" (Step

6 Adjust the speaker volume

level). )

CAUTION

Make sure that the power cord plug is disconnected from the AC

wall outlet before proceeding to speaker cord connections.

If the conductor wires on the extremity of speaker cord are

untwisted, there is a risk of short-circuiting. Be sure to twist

them well before connecting the speaker cord.

Protection circuitry

This unit incorporates protection circuitry, which may be activated

during high-power reproduction or in case of extreme rise in tempera-

ture.

When the protection circuitry is activated, the output from this unit is

shut down and the STANDBY indicator blinks.

In this case, turn this unit OFF then ON again and reduce the output

volume level.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 59 60

Comments to this Manuals

No comments

AEG 7200 Instruction Manual Page 12

Comments to this Manuals