AEG BSS577121M User Manual download pdf (Page 34)

the above steps in the opposite

sequence.

Make sure that you put the glass panels

(A, B and C) back in the correct

sequence. The middle panel (B) has a

decorative frame. The screen-printing

zone must face the inner side of the

door. Make sure that after the installation

the surface of the glass panel frame (B)

on the screen-printing zones is not rough

when you touch it.

A B C

Make sure that you install the middle

panel of glass in the seats correctly.

11.8 Replacing the lamp

WARNING!

Risk of electric shock.

The lamp can be hot.

1. Turn off the oven.

Wait until the oven is cooled down.

2. Disconnect the oven from the mains.

3. Put a cloth on the bottom of the

cavity.

CAUTION!

Always hold the halogen

lamp with a cloth to prevent

grease residue from burning

on the lamp.

The back lamp

1. Turn the lamp glass cover to remove

it.

2. Clean the glass cover.

3. Replace the lamp with a suitable 300

°C heat-resistant lamp.

4. Install the glass cover.

12.

TROUBLESHOOTING

WARNING!

Refer to Safety chapters.

12.1 What to do if...

Problem Possible cause Remedy

You cannot activate or oper-

ate the oven.

The oven is not connected

to an electrical supply or it is

connected incorrectly.

Check if the oven is correctly

connected to the electrical

supply (refer to the connec-

tion diagram if available).

The oven does not heat up. The oven is deactivated. Activate the oven.

The oven does not heat up. The clock is not set. Set the clock.

The oven does not heat up. The necessary settings are

not set.

Make sure that the settings

are correct.

www.aeg.com34

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 43 44

Comments to this Manuals

No comments

AEG BSS577121M User Manual Page 34

Comments to this Manuals

Related products and manuals for Unknown AEG BSS577121M