AEG D100 Installation Guide download pdf (Page 15)

10.2.2 Set the ringer volume

tPress

and / to select “BS SETTINGS”.

tPress

and / to select “RING VOLUME”.

tPress

and / to select the desired ringer volume (a total of 6

ringer volume levels including “VOLUME OFF”).

tPress

to conﬁrm.

Note:

The respective ringer volume will be played during your selection.

10.3 Handset registration

Important:

When you purchase your phone, all handsets are already registered to

your base, so you do not need to register them.

Handset registration is only necessary when you buy extra handsets or if a

handset has become faulty.

You can register additional handsets to have up to ﬁve handsets per base

unit, with each handset‘s number (1 to 5) shown on its display. (Note: each

handset can only be registered to one base.)

To register a new handset to your base:

tPress and hold

on the base station for more than ﬁve seconds, to

put the base station into registration mode. It will stay in registration

mode for about 1 minute, so the following handset sequence must be

completed within this time.

tPress

and / to select “REGISTRATION”.

tPress

to display “PIN?------”.

tEnter the 4-digit system PIN (default 0000).

tPress

to conﬁrm, and the display will show “SEARCHING”.

If the handset registration is successful, you will hear a conﬁrmation tone

and the

will stop ﬂashing.

The handset will automatically be allocated the next available handset

number. This handset number is shown in the handset display in standby

mode. If the handset registration is unsuccessful, the

will still ﬂash.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 37 38

No comments

AEG D100 Installation Guide Page 15