AEG F34300VI0 User Manual

EN User ManualDishwasherFAVORIT34300VIO

The salt is used to recharge the resin inthe water softener and to assure goodwashing results in the daily use.How to fill the salt container1. Turn t

Make sure that the appliance is inprogramme selection mode.• If the salt indicator is on, fill thesalt container.• If the rinse aid indicator is on, f

Make sure that there is detergent in thedetergent dispenser before you start anew programme.End of the programmeWhen the programme is completed theind

• Do not put in the appliance itemsmade of wood, horn, aluminium,pewter and copper.• Do not put in the appliance items thatcan absorb water (sponges,h

2. Remove the filter (C) out of filter (B). 3. Remove the flat filter (A).4. Wash the filters.5. Make sure that there are no residuesof food or soil i

• If you regularly use short durationprogrammes, these can leavedeposits of grease and limescaleinside the appliance. To prevent this,we recommend to

Problem and alarm code Possible cause and solutionThe appliance does not drain the wa-ter.• The end indicator flashes 2 timesintermittently.• Acoustic

11.1 The washing and drying results are not satisfactoryProblem Possible cause and solutionPoor washing results. • Refer to "Daily use", &qu

Problem Possible cause and solutionDull, discoloured or chippedtableware.• Make sure that only dishwasher-safe items are washedin the appliance.• Load

ENGLISH 19

CONTENTS1. SAFETY INFORMATION...32. SAFETY INSTRUCTIONS.

www.aeg.com/shop100008660-A-052015

1. SAFETY INFORMATIONBefore the installation and use of the appliance,carefully read the supplied instructions. Themanufacturer is not responsible i

• Put knives and cutlery with sharp points in the cutlerybasket with the points down or in a horizontalposition.• Do not keep the appliance door open

WARNING!Dangerous voltage.• If the water inlet hose is damaged,immediately disconnect the mainsplug from the mains socket. Contactthe Authorised Servi

3. PRODUCT DESCRIPTION437 9 8 105611 121Upper spray arm2Lower spray arm3Filters4Rating plate5Salt container6Air vent7Rinse aid dispenser8Det

4.1 IndicatorsIndicator DescriptionRunning programme indicator. It comes on when the programme startsand goes off when the programme is completed.End

6. SETTINGS6.1 Programme selectionmode and user modeWhen the appliance is in programmeselection mode it is possible to set aprogramme and to enter the

How to set the water softenerlevelThe appliance must be in programmeselection mode.1. To enter the user mode, press andhold the programme button until