AEG L75480WD User Manual download pdf (Page 31)

Problem Possible cause Possible solution

The appliance fills

with water and

drain immediately.

The end of the drain

hose is too low.

Make sure that the drain hose is

in the correct position.

The washing re-

sults are not satis-

factory.

The detergent you used

was not sufficient or cor-

rect.

Increase the detergent quantity

or use a different one.

You did not remove the

stubborn stains before

you wash the laundry.

Use special products to remove

the stubborn stains.

Incorrect temperature

was set.

Make sure that you set the cor-

rect temperature.

Too much laundry load. Decrease the laundry load.

The appliance

does not dry or

does not dry cor-

rectly.

The water tap is not

turned on.

Turn the tap on.

The drain filter is clog-

ged.

Clean the drain filter.

There is too much laun-

dry in the drum.

Reduce the laundry load.

You have set a wrong

dryness level or drying

time.

Set additional drying time.

The laundry is full

of different col-

ours fluff.

The fabrics washed in

the cycle before re-

leased fluff of different

colours.

• The drying phase helps to re-

move some fluff.

• Clean the laundry with a fluff

remover.

If there is a big quantity

of fluff in the drum re-

peat this procedure

again and again:

• Clean the empty drum, the

gasket and the door with a

wet cloth.

• Set a rinse cycle

• Put a wool or piled fabric

cloth in the drum.

• Set a drying cycle of 10 mi-

nutes

• Remove the old wool cloth.

After the check, activate the appliance.

The programme continues from the

point of interruption.

If the problem occurs again, contact the

service centre.

If the display shows other alarm codes,

contact the service centre.

ENGLISH 31

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 79 80

Comments to this Manuals

No comments