AEG 510 D Operations Instructions download pdf (Page 56)

Protect PV.500 Operating Instructions

80000041664 BAL 55 of 73

7.1.4.2 Configuring the Modbus Protocol

To access the X5 data protocol configuration, you must press <4>

in the main menu:

Figure 19 Data protocol configuration

Press one of the following keys in the “X5 Data Protocol” menu:

<TAB> to configure the Modbus protocol

<CR> to accept the set values. The configuration is finished and

the main menu is opened again.

<ESC> to cancel the configuration. This opens the main menu.

Figure 20 Modbus protocol configuration

Press one of the following keys in the “X5 Data Protocol – Mod-

bus/JBusV2” menu:

• <!> to load the factory setting.

• <1> to configure the Modbus slave address.

• <2> to configure the delay time between a request from the

master and the response from the slave.

• <CR> to accept the set values. The configuration is finished

and the main menu is opened again.

• <ESC> to cancel the configuration. This opens the main menu.

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 73 74

No comments

AEG 510 D Operations Instructions Page 56