AEG BE6915001M User Manual download pdf (Page 23)

ENGLISH 23

11.3 Oven Installation

For all ovens. after the power has been

connected:

1 Position the oven inside the unit and

en-sure that the power cable is not

trapped or in contact with parts of the

oven that heat up.

2 Anchor the oven to the unit with the

screws supplied, screwing them into

the unit through the holes that can be

seen when the door is open.

3 Make sure that the body of the oven

is not in contact with the walls of the

unit and that there is a separation of

at least 2 mm with the adjacent units.

11.4 Technical information

If the appliance does not work, inform

Technical Service of the kind of problem

you are experiencing and give the:

1 Serial Number (S-No)

2 Model of Appliance (Mod.)

You will find this information engraved on

the identification plate. This plate is on the

bottom of the oven and can be seen when

open-ing the door.

• Disconnection from the electrical

supply must be allowed after the oven

is in the installed position.

• With built-in multifunction ovens, the

rear of the unit, corresponding to the

shaded area (A), must have nothing

projecting out (unit reinforcement,

pipes, sockets, etc.).

• The adhesive used in the plastic lining

the kitchen units must be able to

withstand temperatures over 85ºC.

11.2 Electrical Connection

The installer must ensure that:

• The mains power voltage and

frequency correspond to what is

marked on the identification plate.

• The wiring system can withstand the

maximum power marked on the

identification plate.

• After connecting the power, check

that all electrical parts of the oven are

working correctly.

23

450

3172742-002 In-Fr. (AEG) 17/10/14 09:50 Página 23

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 79 80

Comments to this Manuals

No comments