AEG BP7304021M User Manual download pdf (Page 36)

Option Description

1 1:00 h for a

low degree of

dirt

2 1:30 h for a

usual degree

of dirt

3 2:30 h for a

high degree

of dirt

You can use the End function to

delay the start of the cleaning

procedure.

5. Touch to activate the Pyrolysis

function.

12.4 Cleaning reminder

To remind you that the pyrolytic cleaning

is necessary, the cleaning reminder

symbol

flashes in the display after

each deactivation of the appliance for

the next 10 seconds.

The cleaning reminder

goes out:

• after the end of the

pyrolytic cleaning.

• when you deactivate it in

the basic settings. Refer

to "Using the settings

menu".

12.5 Removing and installing

the door

You can remove the door and the

internal glass panels to clean it. The

number of glass panels is different for

different models.

WARNING!

Be careful when you remove

the door from the appliance.

The door is heavy.

1. Open the door fully.

2. Fully press the clamping levers (A) on

the two door hinges.

A

A

3.

Close the oven door to the first

opening position (approximately 70°

angle).

4. Hold the door with one hand on each

side and pull it away from the

appliance at an upwards angle.

5. Put the door with the outer side

down on a soft cloth on a stable

surface. This is to prevent scratches.

6. Hold the door trim (B) on the top

edge of the door at the two sides

and push inwards to release the clip

seal.

1

2

B

7. Pull the door trim to the front to

remove it.

8. Hold the door glass panels on their

top edge one by one and pull them

up out of the guide.

9. Clean the glass panel with water and

soap. Dry the glass panel carefully.

When the cleaning is completed, install

the glass panels and the door. Do the

above steps in the opposite sequence.

Install the smaller panel first, then the

larger.

www.aeg.com

36

1 2 ... 31 32 33 34 35 36 37 38 39 40

Comments to this Manuals

No comments