AEG KSK772220M User Manual download pdf (Page 30)

To stop the pyrolytic

cleaning before it is

completed, turn off the

oven.

When the pyrolytic cleaning

starts, the oven door is

locked and the lamp does

not work.

After the pyrolytic cleaning

is finished, the door stays

locked for the cool down

phase. Some of the oven

functions are not available

during the cool down phase.

WARNING!

After the pyrolytic cleaning

is finished, the oven is very

hot. There is a risk of burns.

Let it cools down.

12.5 Cleaning Reminder

When reminder is displayed cleaning is

necessary. Perform the function Pyrolytic

Cleaning.

You can enable / disable the function:

Cleaning Reminder in the menu: Basic

Settings.

12.6 Steam generation system

- Descaling

When the steam generator operates,

limestone accumulates inside it (because

of calcium contents in the water). This

can have a negative effect on the steam

quality, on the performance of the steam

generator and on the food quality. To

prevent limestone accumulation, clean

the steam generation circuit.

Remove all accessories.

Select the function from the menu:

Cleaning. The user interface will guide

you through the procedure.

The duration of the complete procedure

is about 2 hours.

The light in this function is off.

1. Make sure that the water drawer is

empty.

2. Press .

3. Put the grill- / roasting pan on the

first shelf position.

4. Press

.

5. Put 250 ml of the descaling agent in

the water drawer.

6. Fill the remaining part of the water

drawer with water to the maximum

level until the signal sounds or the

display shows the message.

7. Press

.

This activates the first part of the

procedure: Descaling.

The duration of this part is

around 1 hour 40 minutes.

8. After the end of the first part, empty

the grill- / roasting pan and put it on

the first shelf position again.

9. Press

.

10. Fill the water drawer with fresh water

to the maximum level until the signal

sounds or the display shows the

message.

11. Press .

This activates the second part of the

procedure: Descaling. It will rinse the

steam generation circuit.

The duration of this part is

around 35 minutes.

Remove the grill- / roasting pan after the

end of the procedure.

If the function: Descaling is

not performed in the correct

way, the display will show a

message to repeat it.

If the oven is humid or wet, wipe it out

with a dry cloth. Let the oven dry fully

with the door open.

12.7 Descaling reminder

There are two descaling reminders which

remind you to perform the function:

Descaling. These reminders activate

each time you switch off the appliance.

The soft reminder reminds and

recommends you to perform the

descaling cycle.

The hard reminder obligates you to

perform the descaling.

www.aeg.com

30

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 39 40

Comments to this Manuals

No comments