AEG PROTECT B. 1000 Operations Instructions download pdf (Page 34)

7. Activate the external EPO switch to test the

EPO function

8. De-activate the external EPO switch and restart

the UPS.

5.4 Electric start-up

First compare the setting with the rated voltage valid in your

country. The factory default setting is 230 V

Make any changes in accordance with the description in

chapter 5.4.2 “Configuration”.

5.4.1 Connection

Now connect the input of the UPS (pos. 1 fig. p. 24/25) to the

mains connection cable provided and plug the mains

connector into a suitable shockproof socket.

1. Avoid using extension cables and/or

adapters. In particular in the case of high-

capacity types, ensure that the fusing in your

sub-distribution is adequately dimensioned:

The PROTECT B. 3000 for example requires

its own connection with a 16 A fuse. No other

loads should be connected to this circuit!

2. Then connect the outputs of your UPS (pos.

2 fig. p. 24/25) to your loads. Use the load

connection cables provided for this. Don’t

switch on the loads yet. Please contact your

dealer if you require additional load

connection cables.

3. Now switch on the UPS. To do this, press

and hold the UPS main switch for about 3

seconds until the display goes on.

4. The UPS acknowledges your command by

starting a self test. During this automatically

running procedure a periodically audible

signal can be heard The green "Mains" LED

is permanently illuminated when the normal

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 53 54

No comments

AEG PROTECT B. 1000 Operations Instructions Page 34