AEG PROTECT B. 1000 Operations Instructions download pdf (Page 36)

6. After selecting the mode, press the confirmation

button

more than three seconds to complete the

configuation.

5.5 Operation

Once you have connected the UPS to a suitable mains

connection, you can start operation using the UPS main

switch.

On and Off switch

♦ To switch on the USP press the button for about 3

sec. (until the display goes on).

♦ To switch off the UPS press the button until the UPS

signal stops.

Normally, the UPS operates continuously. The UPS now supplies

the output with voltage, this being signaled by the green LED

LINE MODE which lights up permanently (pos. 7 p. 42).

5.5.1 Normal Operation

During normal operation, i.e. when mains voltage is available,

the built-in battery charger keeps the battery fully charged and

the mains voltage monitoring system switches the inverter to

standby mode.

The connected loads are powered using the monitored and

filtered mains voltage, which is additionally stabilised by the

integrated AVR control unit.

The UPS capacity utilisation can be read off the bar chart of

the operating panel (pos. 9, fig. p. 42).

5.5.2 Battery Operation / Autonomous Operation

When there is a mains failure or if the input voltage moves

outside the tolerance range, the inverter automatically

switches over to autonomous mode and supplies the loads

with voltage from the battery. This drains the capacity of the

battery and it is discharged. This status is signalled by the

yellow LED BAT.MODE flashing as well as an intermittent

acoustic signal (s. p. 42)

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 53 54

No comments

AEG PROTECT B. 1000 Operations Instructions Page 36