USER MANUALEN User ManualWasher DryerL 98485 HWD
DDigit areaTime of the dayWhen you activate the appliance the display shows the time of the day for someseconds. To adjust the clock, refer to "C
FTime saveThe indicator comes on when you set one of the programme dura-tion.Shortened timeExtra QuickG Indicator for air filtersHExtra rinsingThe val
5. PROGRAMS5.1 Programme ChartProgrammeTemperaturerangeMaximum loadMaximum spinspeedProgramme description(Type of load and soil level)Washing/Drying p
ProgrammeTemperaturerangeMaximum loadMaximum spinspeedProgramme description(Type of load and soil level)Super EcoCold3 kg1200 rpmMixed fabric (cotton
ProgrammeTemperaturerangeMaximum loadMaximum spinspeedProgramme description(Type of load and soil level)Refreshup to 1.5 kg Steam programme for cotton
ProgrammeSpinPrewashStainsSoakExtra Rinse1)Time Save2)Delay Start20 Min. - 3 kg Rinse Spin/Drain 1)
Dryness Level Type of fabric Load(kg)Spinspeed(rpm)Suggestedduration(mins)Cupboard DryFor items to be storedCottons and Linen(bathrobes, bath towels,
At the start of the programme, the display shows the programme dura-tion for the maximum load capacity.During the washing phase the programme duration
• To activate/deactivate this functiontouch Time Save and Delay Start atthe same time until the indicator comes on/goes off.8. OPTIONS8.1 Touch Scre
8.10 Extra RinseTouch this button to add rinsing phasesto a programme.Use this function for persons allergic todetergents and in areas where the water
CONTENTS1. SAFETY INFORMATION...32. SAFETY INSTRUCTIONS...
3. Touch Start/Pause button to confirmthe selection.The minute digits flash.4. Turn the programme knob to changethe minutes.5. Touch Start/Pause butto
10.4 Filling the detergent andadditivesCompartment for prewash phase,soak programme or stain remover.Compartment for washing phase.Compartment for liq
When you use the liquiddetergent:• Do not use gelatinousor thick liquiddetergents.• Do not put more liquidthen the maximum level.• Do not set the prew
10.12 Opening the doorWARNING!If the temperature and levelof the water in the drum aretoo high and the drum stillrotates you cannot open thedoor.While
11. DAILY USE - DRYING ONLYWARNING!Refer to Safety chapters.11.1 Preparation to drying1. Press button On/Off for someseconds to activate the appliance
After some minutes fromthe end of theprogramme, the energysaving functionautomatically deactivatesthe appliance.1. Remove the laundry from theapplianc
12.4 At the end of theprogrammeThe appliance stops automatically. Theacoustic signals operate (if they areactive).For more information see ‘At the end
13.3 Detergents and additives• Only use detergents and additivesspecially made for washing machines:– powder detergents for all types offabric,– powde
13.9 Drying cycle durationThe drying time can change dependingon:• speed of the last spin• dryness level• type of laundry• weight of the load13.10 Add
14.5 Cleaning the detergent dispenser1.122.3. 4.14.6 Cleaning the air filtersThe air filters collect the fluff. The fluff normally occurs when the clo
1. SAFETY INFORMATIONBefore the installation and use of the appliance,carefully read the supplied instructions. Themanufacturer is not responsible f
3. PULL4. PULL5. PULL6. 7. 8. 9.10. +To have best drying performances clean regularly the air filters with warmwater and afterwards dry them with a t
14.7 Cleaning the drain filterWARNING!Do not clean the drain filter if the water in the appliance is hot.WARNING!Each time you carry out the special p
7. 8.129.12 14.8 Cleaning the inlet hose filter and the valve filterIt could be necessary to clean the filters when:• The appliance does not fill with
• Remove the inlet hose behind theappliance.• Clean the filter in the valve with a stiffbrush or a towel.45°20°• Install again the inlet hose. Make su
WARNING!Make sure that the temperature is more than 5 °C and the water is flowingfrom the tap before you use the appliance again.The manufacturer is n
Message Possible solution Make sure that the connection of the drain hose is cor-rect.The display tells to check thedoor.Make sure that the appliance
Problem Possible solution Make sure that the drain filter is not clogged. Clean thefilter, if necessary. Refer to 'Care and cleaning'. Mak
Problem Possible solutionThe washing cycle is longerthan the time displayed.An unbalanced laundry load increases the duration time.This is a normal be
1. Press the On/Off button to switch theappliance off.2. Disconnect the mains plug from themains socket.3. Open the filter flap.4. Keep the emergency
• Remove the cardboard top.• Remove the polystyrene packagingmaterials.• Remove the internal film.• Open the door.• Remove the polystyrene piece fromt
• Do not install the appliance behind a lockable door, asliding door or a door with a hinge on the oppositeside, that would prevent the appliance door
• Fully clean and dry the bottom of theappliance.• Do not use alcohol, solvents orchemical products.ABMake sure to identify the different sizesand the
• Remove the power supply cable andthe drain hose from the hose holders.It is possible to see waterflowing from the drainhose. This is due to thetesti
16.3 Installation under a counter600 mm600 mm≥ 870 mmThe appliance can be installed asfreestanding or below the kitchen counterwith correct space (see
16.5 The inlet hose20O20O45O45O• Connect the hose to the back appliance.Turn the inlet hose only left or right.• Loose the ring nut to set it in the c
• Make a U shape with the drain hose.On the edge of a sink• Make sure that the plastic guide cannotmove when the appliance drains. Attachthe guide to
To a sink spigot• Refer to the illustration. Put the drain hosein the spigot and tighten it with a clip.• Make sure that the drain hose makes aloop to
Wool 1 kgSpin Speed Maximum 1400 rpmThis product contains HFC - R134a/GWP1430 0.12 kg fluorinated gas hermetically sealed.1) Connect the water inlet
ENGLISH 47
www.aeg.com/shop132958602-A-012017
amount of detergent before being dried in the washerdryer.• Do not use the appliance if items have been soiledwith industrial chemicals.• Do not dry u
• The floor area where the appliance isto be installed must be flat, stable,heat resistant and clean.• Keep the transit bolts in a safe place.If the a
2.6 Disposal• Disconnect the appliance from themains electrical and water supplies.• Cut off the mains electrical cableclose to the appliance and disp
3.3 Accessories1 245 31 SpannerTo remove the transit bolts.2 Plastic capsTo close the holes on the rear side ofthe cabinet after the removal of thetra
11Option touch button (Stains/Prewash)12Spin reduction touch button (Spin)13Temperature touch button (Temp.)4.2 DisplayA B C DEFGHIJKThe display shows
Comments to this Manuals