L 87484 AFL EN User manual
5.10 Temperature button 10Press button 10 to change the defaulttemperature. When the display shows - -, the appliance does not heat the wa-ter.5.11 Ac
ProgrammeTemperatureType of loadMax. weight of loadCycledescrip-tionFunctionsPflegeleicht60° - ColdSynthetic or mixed fabricitems with normal soil.max
ProgrammeTemperatureType of loadMax. weight of loadCycledescrip-tionFunctionsSchleudern /Pumpen5)0°All fabrics.The maximum load of thelaundry is relat
8) Standard programmes for the Energy Label consumption values. According toregulation 1061/2010, the «Baumwolle Eco 60 °C» and «Baumwolle Eco 40 °C»
7. CONSUMPTION VALUESThe data of this table are approximate. Different causes can change the da-ta: the quantity and type of laundry, the water and am
9. USING THE APPLIANCE1.Open the water tap.2.Connect the mains plug to the mainssocket.3.Press button 1 to activate the ap-pliance.4.Put the laundry i
This is the maximum level for the quantity of liquid additives.The compartment for the stain remover.Put the product in the compartment and set the st
5.Measure out the detergent and thefabric conditioner.6.Carefully close the detergent dis-penser. Make sure that the flapdoes not cause a blockage whe
To open the appliance door:1.Press button 4 . The door locksymbol in the display goes off.2.Open the appliance door.3.Close the appliance door and pre
11. HELPFUL HINTS AND TIPS11.1 The laundry load• Divide the laundry in: white, coloured,synthetics, delicates and wool.• Obey the washing instructions
CONTENTS1. SAFETY INFORMATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 32. TECHNICAL I
Water hardness tableLevel TypeWater hardness°dH °T.H. mmol/l Clarke1 soft 0-7 0-15 0-1.5 0-92 medium 8-14 16-25 1.6-2.5 10-163 hard 15-21 26-37 2.6-3.
12.6 Detergent dispenserTo clean the dispenser:121.Press the lever.2.Pull the dispenser out.3.Remove the top part of the liquidadditive compartment.4.
To clean the drain pump:1.Open the drain pump door.2.Pull the flap out to remove it.3.Put a container below the recess ofthe drain pump to collect the
129.Clean the filter under the water tapand put it back in the pump into thespecial guides.10.Make sure that you tighten correctlythe filter to preven
Put the drainage duct back and close thedrain pump flap.When you drain the water with the emer-gency drain procedure, you must acti-vate again the dra
Problem Possible cause Possible solutionThe appliancedoes not drain thewater.The water drain hose isdamaged.Make sure that the water drainhose has no
Problem Possible cause Possible solution Leakages from the drainpump.Make sure that the drain pumpfilter is tight. The water drain hose isdamaged.Ma
14.2 Unpacking1.Use the gloves. Remove the externalfilm. If necessary, use a cutter.2.Remove the cardboard top.3.Remove the polystyrene packagingmater
6.Put one of the polystyrene packag-ing elements on the floor behindthe appliance. Carefully put downthe appliance with the rear side onit. Make sure
12.Put the plastic caps in the holes.You can find these caps in the usermanual bag.WARNING!Remove all the packaging andthe transit bolts before you in
1. SAFETY INFORMATIONBefore the installation and use, read thismanual carefully:• For your safety and the safety of yourproperty• To help the environ
14.4 The inlet hose20O20O20O45O45O45O• Connect the hose to the appliance.Turn the inlet hose only left or right.Loose the ring nut to set it in the co
With the plastic hose guide. • On the edge of a sink.• Make sure that the plastic guide can-not move when the appliance drains.Attach the guide to the
You can extend the drain hose tomaximum 400 cm. Contact theservice centre for the other drainhose and the extension.15. ENVIRONMENT CONCERNSRecycle th
ENGLISH 33
34www.aeg.com
ENGLISH 35
www.aeg.com/shop132924900-A-192012
• Do not install and connect a damagedappliance.• Make sure to remove all packagingand transport bolts.• Make sure that the mains plug is dis-connecte
Water supply pressure Minimum 0,5 bar (0,05 MPa)Maximum 8 bar (0,8 MPa)Water supply 1) Cold waterMaximum load Cotton 8 kgSpin speed Maximum 1400 rpm1
4. ACCESSORIES1 2341SpannerTo remove the transit bolts.2Plastic capsTo close the holes on the rear sideof the cabinet after the removal ofthe transit
• After 5 minutes from the end of thewashing programme. Refer to 'At theend of programme'.5.2 Programme knob 2Turn this knob to set a progra
EThe detergent overdosing comes on at the end of the cy-cle when the appliance detects too much detergent.FYou cannot open the appliance door when the
KThe extra rinse symbol comes on when this function is acti-vated.The value shows the total number of the rinses.The indicator bar is fully filled whe
Comments to this Manuals