AEG L87405FL Quick Start Guide download pdf (Page 3)

START THE APPLIANCE

Before First Use

1. Activate the drain system:

put 2 litre of water in the main wash compartment of the

detergent dispenser.

2. Set and start a programme for cotton at the highest

temperature without laundry to remove all possible dirt from

the drum and the tub. Put a small quantity of detergent in the

main wash compartment of the detergent dispenser.

Daily Use

1. Open the water tap.

2. Connect the mains plug to the mains socket.

3. Press On/Off button to activate the appliance.

4. Put the laundry in the drum, one item at a time. Make sure that

there is no laundry trapped between the seal and the door.

5. Close the door.

6. Put the detergent and additives in the correct compartment of

the dispenser.

7. Turn the programme knob to set a programme.

The programme indicator goes on.

8. The display shows the default temperature, maximum spin

speed and the empty indicator bar of the available functions.

To change the default values or to set functions press the

corresponding buttons.

9. If necessary, set the delay start function.

10. Press Start/Pause button to start the washing programme.

Press this button also to interrupt it.

After approximately 15 minutes from the start of the

programme, the display shows the new time value.

11. At the end of the programme the display shows a zero (

the symbol of the last washing phase is on. The indicator of the

Start/Pause button and the door lock symbol go off.

12. If you set the Rinse Hold function refer to “At the end of the

programme” chapter in the user manual.

1 2 3 4

No comments

AEG L87405FL Quick Start Guide Page 3