USER MANUALEN User ManualWashing MachineL7FC8432BI
The inlet hose1. Remove the inlet hose from inside thedrum.2. To connect the water inlet hose towardsthe proper direction and with the properinclinati
Ø 40 mmTo a stand pipe with vent-holeDirectly into a drain pipe at a height of notless than 60 cm (23.6”) and not more than 100cm (39.3”).The end of t
553 mm596 mm140 mm76 mm50 mm50 mm819 mmIf hoses run behind theappliance, make sure thatnothing closes the smallrecess indicated with themeasures 50 x
1. Remove the screws of the top cover on therear of the appliance and install the anti-tilting device as shown in the drawing.~10mm2. Adjust the anti-
Reversibility of the cupboard doorCarry out the cupboard door reversibilitybefore the appliance is built in completely.MNOIf the cupboard door has to
16-22 mm22±1,5 mm449mm595-598 mmØ 35 mm12,5 - 14 mmSet the position of the lower hole respectingdimensions and distances shown in thedrawing (449 mm).
2N1EDCCounter-magnetThe appliance is pre set for a magneticclosure.For a correct closure:1. Position the screw C and the counter-magnet D on the magne
5. CONTROL PANEL5.1 Control panel description112 9 810111372 3 4 5 6On/OffStart/PauseCottonsSyntheticsDelicatesOutdoorSteamSpin/DrainRinseAnti-allergyD
The Temperature area: Temperature indicator . Cold water indicator.Child safety lock indicator.Door locked indicator.Delay start indicator.The digital
6. DIAL AND BUTTONS6.1 IntroductionThe options/functions arenot available with allwashing programmes. Checkthe compatibility betweenoptions/functions
CONTENTS1. SAFETY INFORMATION...32. SAFETY INSTRUCTIONS...
cheaper electricity tariffs are available.In some programmes the rinses areperformed with more water.If you touch the Start/Pause button,the appliance
6.11 Child LockWith this option you can prevent childrenfrom playing with the control panel.To activate/deactivate this option, holddown the Plus Stea
7. PROGRAMMES7.1 Programme ChartProgrammeDefault tem-peratureTemperaturerangeReferencespin speedSpin speedrangeMaxi-mumloadProgramme description(Type
ProgrammeDefault tem-peratureTemperaturerangeReferencespin speedSpin speedrangeMaxi-mumloadProgramme description(Type of load and soil level)Outdoor30
ProgrammeDefault tem-peratureTemperaturerangeReferencespin speedSpin speedrangeMaxi-mumloadProgramme description(Type of load and soil level)Steam-1 k
ProgrammeDefault tem-peratureTemperaturerangeReferencespin speedSpin speedrangeMaxi-mumloadProgramme description(Type of load and soil level)20min 3kg
ProgrammeSpin No SpinPrewash1)Stains 2)Extra RinseSoft PlusPlus SteamDelay StartTime SaveCottons Eco Synthetics
8. SETTINGS8.1 Acoustic signalsThis appliance has different acousticsignals, that operate when:• You activate the appliance (specialshort tune).• You
CAUTION!Make sure that no laundrygets caught between theseal and the door to avoidrisk of water leakage anddamage to the laundry.Washing heavily oiled
• Do not exceed to liquiddetergent dose indicated on theflap.• Do not set the prewash phase.• Do not set the delay startfunction.5. Measure out the de
1. SAFETY INFORMATIONBefore the installation and use of the appliance,carefully read the supplied instructions. Themanufacturer is not responsible f
10.8 The ProSense Systemload detectionThe programme duration inthe display is referred to a medium/high load.After touching the Start/Pause button,the
10.11 Opening the door -Adding garmentsIf the temperature and levelof the water in the drum aretoo high and/or the drum isstill rotating you should no
Turn the programme dial to set a newcycle.If the dial is rotated to the "Reset"position , the appliance automaticallyturns off in 30 second
11.4 Ecological hints• Set a programme without theprewash phase to wash laundry withnormal soil.• Always start a washing programmewith the maximum loa
buttons, other small items forgotten inthe pockets of your clothes aredeposited during the washing cycle inthe special double lip trap in theporthole
rinsing programme without anyclothes in the drum.12.7 Cleaning the drain pumpWARNING!Disconnect the mains plugfrom the mains socket.Regularly check th
180˚3. Turn the filter 180 degrees in anti-clockwisedirection to open it, without removing. Let thewater flow out.4. When the bowl is full of water, t
219. Put the filter back into the special guides byturning it clockwise. Make sure that youtighten the filter correctly to prevent leakages.1210. Clos
45°20°12.9 Emergency drainIf the appliance cannot drain the water,carry out the same procedure, describedin 'Cleaning the drain pump' paragr
• - No communication between electronic elements of the appliance. Switch itoff and switch on again. The programme was not finished properly or the a
– by clients in hotels, motels, bed & breakfast andother residential type environments;– areas for communal use in blocks of flats or inlaunderett
Problem Possible solutionThe appliance does notfill with water properly.• Make sure that the water tap is open.• Make sure that the pressure of the wa
Problem Possible solutionThe appliance makes anunusual noise and vi-brates.• Make sure the levelling of the appliance is correct. Refer to"Instal
2. Disconnect the mains plug from themains socket.3. Pull twice the emergency unlocktrigger downward and open theappliance door. The emergencyunlock t
Programmes Load(kg)Energyconsump-tion (kWh)Waterconsump-tion (litre)Approxi-mate pro-grammeduration(minutes)Remain-ing mois-ture (%)1)Standard cotton
16. PRODUCT INFORMATION SHEET IN REFERENCETO E.U. REGULATION 1369/2017Product Information SheetTrade Mark AEGModel L7FC8432BI, PNC914580005Rated capac
Programme time of the "standard 40°C cotton pro-gramme at partial load in minutes235Duration of the left on mode in minutes 5Airborne acoustical
www.aeg.com46
ENGLISH 47
www.aeg.com/shop157019870-B-292018
• The floor area on which the applianceis to be installed must be flat, stable,heat resistant and clean.• Make sure that there is air circulationbetwe
2.5 Service• To repair the appliance contact anAuthorised Service Centre.• Use original spare parts only.2.6 DisposalWARNING!Risk of injury or suffoca
1. Put two polystyrene packagingelements on the floor under theappliance.WARNING!It is stronglyrecommended that thisaction is carries out by twoperson
6. Remove the three bolts, the hoseholders and plastic spacers by using thespanner supplied with the appliance.FG7. Close the holes with the plastic c
3.5 Positioning and levellingx41. Install the appliance on a flat hard floor.WARNING!Make sure that carpets do notstop the air circulation belowthe ap
Comments to this Manuals