AEG L76475FL User Manual

L 76475 FLL 76675 FLEN User manual

Spin phase is off.'Rinse Hold' function ison.5.10 Temperature button 10Press button 10 to change the defaulttemperature.- - = cold water5.11

ProgrammeTemperatureType of loadmax. weight of loadCycledescriptionFunctionsExtra Stil95° - ColdWhite and colouredcotton with normalsoil.max. 7 kgWash

ProgrammeTemperatureType of loadmax. weight of loadCycledescriptionFunctionsGordijnen40° - ColdSet this programmeto wash curtains. Itadds automaticall

6) Set this programme to decrease the time and the consumption of energy and water.7) STANDARD PROGRAMMES for the Energy Label consumption values.Acco

Off Mode (W) Left-On Mode (W)0.48 0.48The information given in the charts above are in compliance with the EU Com-mission regulation 1015/2010 impleme

9.2 Filling the detergent and additivesThe detergent compartment for the prewash phase, the soakprogramme and for the stain function.Add the detergent

3.To use powder detergent, turn theflap up.4.To use liquid detergent, turn theflap down.With the flap in the positionDOWN:– Do not use gelatinous or t

1.Press button 4 . The indicatorflashes.2.Change the function set.9.7 Set the delay start1.Press button 5 again and again un-til the display shows the

10. HINTS AND TIPS10.1 The laundry load• Divide the laundry in: white, coloured,synthetics, delicates and wool.• Obey the washing instructions that ar

Water hardness tableLevel TypeWater hardness°dH °T.H. mmol/l Clarke1 soft 0-7 0-15 0-1.5 0-92 medium 8-14 16-25 1.6-2.5 10-163 hard 15-21 26-37 2.6-3.

CONTENTS1. SAFETY INFORMATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 32. SAFETY

11.6 Detergent dispenserTo clean the dispenser:121.Press the lever.2.Pull the dispenser out.3.Remove the top part of the liquidadditive compartment.4.

To clean the drain pump:1.Open the drain pump door.2.Pull the flap out to remove it.3.Put a container below the recess ofthe drain pump to collect the

129.Clean the filter under the water tapand put it back in the pump into thespecial guides.10.Make sure that you tighten correctlythe filter to preven

Put the drainage duct back and close thedrain pump flap.When you drain the water with the emer-gency drain procedure, you must acti-vate again the dra

Problem Possible cause Possible solutionThe appliancedoes not drain thewater.The water drain hose isdamaged.Make sure that the water drainhose has no

Problem Possible cause Possible solution Leakages from the drainpump.Make sure that the drain pumpfilter is tight. The water drain hose isdamaged.Ma

13.2 Unpacking1.Use the gloves. Remove the externalfilm. If necessary, use a cutter.2.Remove the cardboard top.3.Remove the polystyrene packagingmater

6.Put one of the polystyrene packag-ing elements on the floor behindthe appliance. Carefully put downthe appliance with the rear side onit. Make sure

12.Put the plastic caps in the holes.You can find these caps in the usermanual bag.– We recommend that you keepthe packaging and the transitbolts for

CAUTION!Do not put cardboard, wood orequivalent materials below theappliance feet to adjust the level.13.4 The inlet hose20O20O20O45O45O45O• Connect t

1. SAFETY INFORMATIONBefore the installation and use of the appliance, careful-ly read the supplied instructions. The manufacturer isnot responsible i

13.5 Water drainageThere are different procedures to con-nect the drain hose:With the plastic hose guide. • On the edge of a sink.• Make sure that the

• Directly to a built-in drain pipe in theroom wall and tighten it with a clip.You can extend the drain hose tomaximum 400 cm. Contact theservice cent

www.aeg.com/shop132918571-A-142013

• If the supply cord is damaged, it must be replaced bythe manufacturer, its service agent or similarly quali-fied persons in order to avoid a hazard.

Water connection• Make sure not to cause damage to thewater hoses.• The appliance is to be connected tothe water mains using the new sup-plied hose-se

Water supply pressure Minimum 0,5 bar (0,05 MPa)Maximum 8 bar (0,8 MPa)Water supply 1) Cold waterMaximum load Cotton 7 kgSpin speed Maximum 1400 rpm

4.1 Accessories1 2341SpannerTo remove the transit bolts.2Plastic capsTo close the holes on the rear sideof the cabinet after the removal ofthe transit

• After 5 minutes from the end of thewashing programme. Refer to 'At theend of programme'.5.2 Programme knob 2Turn this knob to set a progra

D • The programme timeWhen the programme starts, the time decreases with steps of 1 mi-nute.• The delay startWhen you press the delay start button, th