AEG L61470BI User Manual download pdf (Page 22)

To clean the water inlet filters:

1.

Close the water tap.

2.

Remove the water inlet hose from

the water tap.

3.

Clean the filter in the inlet hose with

a stiff brush.

4.

Remove the inlet hose behind the

appliance.

5.

Clean the filter in the valve with a

stiff brush or a towel.

45°

20°

6.

Install again the inlet hose. Make

sure that the couplings are tight to

prevent leakages.

7.

Open the water tap.

11.8 Emergency emptying out

If the water is not discharged, proceed

as follows to empty out the appliance:

1.

pull out the plug from the power

socket;

2.

close the water tap;

3.

if necessary, wait until the water has

cooled down;

4.

place a bowl on the floor;

5.

place the end of the emergency

emptying hose into the bowl;

6.

Remove its cap. The water should

drain by gravity into the bowl. When

the bowl is full, put the cap back on

the hose. Empty the bowl;

Repeat the procedure until water

stops flowing out;

7.

clean the pump if necessary as previ-

ously described;

8.

replace the emergency emptying

hose in its seat after having plugged

it;

9.

screw the pump again.

11.9 Frost precautions

If the machine is installed in a place

where the temperature could drop be-

low 0°C, proceed as follows:

1.

close the water tap;

2.

unscrew the water inlet hose from

the tap;

3.

place the end of the emergency

emptying hose and that of the inlet

hose in a bowl placed on the floor.

Let water drain out;

4.

screw the water inlet hose back on;

5.

put the cap on the emergency emp-

tying hose again;

6.

reposition the emergency emptying

hose.

22

www.aeg.com

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 35 36

Comments to this Manuals

No comments