AEG BE7900061M User Manual download pdf (Page 35)

NATURAL GAS CONVERSION

Model 49669GO-MN

This appliance is supplied set up to for LPG usage. A

conversion kit is included with the product for natural

gas usage. The conversion kit contains 6 injectors and

natural gas sticker.

Please follow the procedure below if a conversion to

suit natural gas is required.

1. Remove the hotplate trivets, burner caps and burner

crowns to access the hotplate injectors. Replace the

factory fitted injectors with the appropriate injectors,

as supplied. Refer to injector orifice table for injector

sizes. The injector size is stamped on the side of

the injector.

2. Turn on the gas supply and at each new connection

check for leaks using soapy water: each hotplate

valve should be turned on, one at a time, and the

injector hole blanked off for several seconds.

3. One by one, turn the knobs to minimum and adjust

the bypass screw (accessible when the knob is

removed) until a small stable flame results. Turn the

knob to maximum and then back to minimum to

ensure that the correct minimum flame

is maintained.

4. Attach the natural gas sticker to the cooker, near

the gas supply inlet. Cover the LPG label that is

factory fitted.

Flame size adjusted to maximum

Flame size adjusted to minimum

Bypass screw

Control knob shaft

1 2 ... 30 31 32 33 34 35 36 37 38

No comments

AEG BE7900061M User Manual Page 35