AEG UN 6.03 Technical Information download pdf (Page 36)

Practical A.E.G Upgrade 2006

of the o-ring and the o-ring space in the piston head.

• imprecise inner barrel – the relatively lower level of manufacturing

capability makes it generally more difficult for the Chinese manufacturers

to produce tighter inner barrels.

• relatively unstable hopup - gap between parts and poor rubber used in the

bucking can loosen the hopup mechanism

• easy thread stripping- this often happens on the plastic parts - remember,

the majority of parts found in the ACM AEGs are plastic based.

• poor wires – the plastic shielding of the wires tend to melt under high heat.

The good news is, since these ACMs are almost identical to the TMs, parts are

100% TM compatible. Therefore, you won’t have difficulties finding replacement

parts.

Warning – stock mechbox lubing is often insufficient

TM and AE have been doing okay in terms of mechbox lubing. ACM internals tend

to be over-lubed. Other AEG internals such as those from CA, ICS and Cybergun

are often poorly lubed. If you open up their mechboxes you will be shocked by

how dry their gears and pistons are. Get them properly lubed with grease can

significantly lengthen their lifespan. However, don’t use the WD40 type of

lubricants inside your mechbox. WD40 fails to stick on the gears, thus producing

no cushioning effect at all.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 156 157

No comments

AEG UN 6.03 Technical Information Page 36