AEG MCD2660E Service Manual download pdf (Page 33)

SOI 03.06 FV 33/38 599 36 78-45

COMPONENT REPLACEMENT AND ADJUSTMENT PROCEDURE

DOOR DISASSEMBLY

REMOVAL

1. Disconnect the power supply cord.

2. Open the door slightly and remove the

built in frame assembly(Ref: to chapter

built in frame assembly removal).

3. Remove the choke cover taking care not

to break clips by inserting an iron plate

(thickness of about 0.5mm) or flat type

screw driver to the gap between the choke

cover and door panel as shown Figure C-4

to free the engaged parts.

4. Release choke cover from door panel.

5. Now choke cover is free.

Figure C-4. Door Disassembly

6. Release two (2) pins of door panel from

two (2) holes of upper and lower oven

hinges by lifting up.

7. Remove door assy by removing screws

(4).

8. Release door panel from tabs of door

frame and remove door frame.

9. Now, door panel with inner sealer film is

free.

10.Tear inner sealer film from door panel.

11.Now, door panel is free.

12.Slide latch head upward and remove it

from door frame with releasing latch spring

from door frame and latch head.

13.Now, latch head and latch spring are free.

RE-INSTALL

1. Re-install latch spring to the head.

Reinstall latch spring to the door frame.

Reinstall latch head to the door frame.

2. Re-install door panel to door frame by

fitting tabs of door frame to holes of door

panel.

3. Put sealer film on door panel. Refer to

“Inner Sealer Film” and figure C-6, on how

to handle the new film.

4. Catch two (2) pins of door panel on two (2)

hole of upper and lower oven hinges.

5. Re-install choke cover to door panel by

pushing.

Note: After any service to the door;

(A) Make sure that monitored latch switch, stop

switch and monitor switch are operating properly. (Refer

to chapter “Test Procedures , Switch Test page 21”.).

(B) An approved microwave survey meter should be used

to assure compliance with proper microwave

radiation emission limitation standards.

After any service, make sure of the following :

1. Door latch heads smoothly catch latch hook through latch

holes and that latch head goes through centre of latch hole.

2. Deviation of door alignment from horizontal line of cavity face

plate is to be less than 1.0mm.

3. Door is positioned with its face pressed toward cavity face

plate.

4. Check for microwave leakage around door with an

approved microwave survey meter. (Refer to Microwave

Measurement Procedure.)

Note: The door on a microwave oven is designed to act as an

electronic seal preventing the leakage of microwave

energy from oven cavity during cook cycle. This function

does not require the door be air-tight, moisture

(condensation)-tight or light-tight. Therefore, occasional

appearance of moisture, light or sensing of gentle warm

air movement around oven door is not abnormal and

does not indicate leakage of microwave energy from the

oven cavity.

Figure C-5. Door Replacement

NOTE: When carrying out any repair to the door, do not

bend or warp the slit choke (tabs on the door panel

assembly) to prevent microwave leakage.

Choke Cover

Putty Knife

Door Frame

UPPER

OVEN HINGE

DOOR SUB

SSEMBL

DOOR

PANEL

SLIT CHOCHE

CHOKE COVER

LOWER

OVEN HINGE

1 2 ... 28 29 30 31 32 33 34 35 36 37 38

Comments to this Manuals

No comments

AEG MCD2660E Service Manual Page 33

Comments to this Manuals

Related products and manuals for Microwaves AEG MCD2660E