AEG MCD2660E Service Manual Page 31

  • Download
  • Add to my manuals
  • Print
  • Page
    / 38
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 30
SOI 03.06 FV 31/38 599 36 78-45
COMPONENT REPLACEMENT AND ADJUSTMENT PROCEDURE
OVEN LAMP REMOVAL
1. CARRY OUT 3D CHECKS.
2. Disconnect the wire lead from the oven lamp
3. Lift up the oven lamp from the clips of the air
intake duct.
4. Now, the oven lamp is free.
POWER SUPPLY CORD REPLACEMENT
Removal
1. CARRY OUT 3D CHECKS.
2. Remove the one (1) screw holding the
green/yellow wire to the cavity back plate.
3. Disconnect the leads of the power supply cord
from the noise filter, referring to the Figure
C-4(a).
4. Release the power supply cord from the rear
cabinet.
5. Now the power supply cord is free.
Re-install
1. Insert the moulding cord stopper of power supply cord
into the square hole of the power angle, referring
to the Figure C-4(b).
2. Install the earth wire lead of power supply cord to the
oven cavity with one (1) screw and ensure that this
screw is tight.
3. Connect the brown and blue wire leads of power
supply cord to the noise filter correctly, referring to the
Pictorial Diagram.C-4(a).
Figure C-4 (a) Replacement of Power Supply Cord Figure C-4 (b). Installation of Power Supply Cord
GRILL HEATING ELEMENT REMOVAL
1. CARRY OUT 3D CHECKS.
2. Remove the one (1) screw holding the exhaust
duct to the oven cavity.
3. Remove the exhaust duct from the oven cavity.
4. Remove the two (2) screws holding the two (2)
terminals of main wire harness to the grill
heating element.
5. Remove the two (2) screws holding the two (2) grill
heater angles to the top of the oven cavity.
6. Remove the two (2) grill heater angles from the oven
cavity.
7. Remove the grill heating element from the top of the
oven cavity.
8. Now the grill heating element is free.
Socket
Bulb
Lock
Oven lamp
Noise filte
r
Power su
pp
l
y
cord
Green / Yellow
Blue Wire
Brown Wire
Wire
Screw
Oven cavity back plate
POWER
SUPPLY CORD
OVEN CAVITY
BACK PLATE
SQUARE HOLE
Page view 30
1 2 ... 26 27 28 29 30 31 32 33 34 35 36 37 38

Comments to this Manuals

No comments