AEG 6561G-M User Manual download pdf (Page 14)

14

It is not necessary to attach the

reinforcement beam to the table

surface, as it is held in place by a

specially designed moulding, which is

incorporated in the hob units flanges.

Installation in work tops with a

base unit underneath

If the hob is to be installed on top of a

base unit, a board must be mounted

underneath the hob (e.g. 16 mm chip

board).

Seal all joints with aluminium tape.

The board can be mounted as shown in

the diagram.

This installation method prevents the

flames from being extinguished if you

close the door of the base unit hard.

If the back panel of the cupboard unit

is of thin 4 mm material, it will need to

be reinforced.

This procedure will prevent the gas

being blown out if the cupboard door

is slammed shut.

Min. 140 mm

Min. 16 mm

Aluminium-tape

Min. 140 mm

Min. 16 mm

Aluminium-tape

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20 21

Comments to this Manuals

No comments