AEG F65402VI0P User Manual download pdf (Page 16)

Problem and alarm code Possible solution

You cannot activate the ap-

pliance.

• Make sure that the mains plug is connected to the

mains socket.

• Make sure that there is no a damage fuse in the fuse

box.

The programme does not

start.

• Make sure that the appliance door is closed.

• If the delay start is set, cancel the setting or wait for the

end of the countdown.

• The appliance has started the procedure to recharge

the resin inside the water softener. The duration of the

procedure is approximately 5 minutes.

The appliance does not fill

with water.

The display shows .

• Make sure that the water tap is open.

• Make sure that the pressure of the water supply is not

too low. For this information, contact your local water

authority.

• Make sure that the water tap is not clogged.

• Make sure that the filter in the inlet hose is not clogged.

• Make sure that the inlet hose has no kinks or bends.

The appliance does not

drain the water.

The display shows .

• Make sure that the sink spigot is not clogged.

• Make sure that the drain hose has no kinks or bends.

The anti-flood device is on.

The display shows .

• Close the water tap and contact an Authorised Service

Centre.

Once you have checked the appliance,

deactivate and activate the appliance. If

the problem occurs again, contact an

Authorised Service Centre.

For alarm codes not described in the

table, contact an Authorised Service

Centre.

12.1 The washing and drying results are not satisfactory

Problem Possible solution

There are whitish streaks or

bluish layers on glasses and

dishes.

• The release quantity of rinse aid is too much. Adjust

the rinse aid selector to a lower position.

• The quantity of detergent is too much.

There are stains and dry water

drops on glasses and dishes.

• The released quantity of rinse aid is not sufficient. Ad-

just the rinse aid selector to a higher position.

• The quality of the rinse aid can be the cause.

The dishes are wet. • The programme does not have a drying phase or has

a drying phase with low temperature.

• The rinse aid dispenser is empty.

• The quality of the rinse aid can be the cause.

• The quality of the multi-tablets can be the cause. Try a

different brand or activate the rinse aid dispenser and

use rinse aid and multi-tablets together.

www.aeg.com16

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 55 56

Comments to this Manuals

No comments

AEG F65402VI0P User Manual Page 16

Comments to this Manuals

Related products and manuals for Dishwashers AEG F65402VI0P