AEG BEM451110M User Manual download pdf (Page 29)

9. Clean the glass panel with water and

soap. Dry the glass panel carefully.

When the cleaning is completed, do the

above steps in the opposite sequence.

Install the smaller panel first, then the

larger and the door.

One of the hinge-arms

(normally the right one) is

free to move. Make sure,

that both hinge-arms are in

the same position

(approximately 70° angle).

WARNING!

Make sure that the glasses

are inserted in the correct

position otherwise the

surface of the door may

overheat.

11.7 Replacing the lamp

WARNING!

Risk of electric shock.

The lamp can be hot.

1. Turn off the oven.

Wait until the oven is cooled down.

2. Disconnect the oven from the mains.

3. Put a cloth on the bottom of the

cavity.

The top lamp

1. Turn the lamp glass cover to remove

it.

2. Clean the glass cover.

3. Replace the lamp with a suitable 300

°C heat-resistant lamp.

4. Install the glass cover.

12. TROUBLESHOOTING

WARNING!

Refer to Safety chapters.

12.1 What to do if...

Problem Possible cause Remedy

You cannot activate or oper-

ate the oven. The display

shows “400” and an acoustic

signal sounds.

The oven is incorrectly con-

nected to an electrical sup-

ply.

Check if the oven is correctly

connected to the electrical

supply (refer to the connec-

tion diagram if available).

The oven does not heat up. The oven is deactivated. Activate the oven.

The oven does not heat up. The clock is not set. Set the clock.

The oven does not heat up. The necessary settings are

not set.

Make sure that the settings

are correct.

ENGLISH 29

1 2 ... 24 25 26 27 28 29 30 31 32

Comments to this Manuals

No comments

AEG BEM451110M User Manual Page 29

Comments to this Manuals

Related products and manuals for Cookers AEG BEM451110M