AEG LAVAMAT 62840 User Manual download pdf (Page 45)

Important!

The drain hose may be extended to a maximum of 4 metres. An additional drain hose and

joining piece is available from your local Service Centre.

Electrical connection

This machine is designed to operate on a 220-230 V, single-phase,

50 Hz supply.

Check that your domestic electrical installation can take the maximum load

required (2.2 kW), also taking into account any other appliances in use.

Connect the machine to an earthed socket.

The manufacturer does not accept any responsibility for damage or

injury through failure to comply with the above safety precaution.

Permanent connection

In the case of a permanent connection it is necessary that you install a double pole

switch between the appliance and the electricity supply (mains), with a minimum

gap of 3 mm between the switch contacts and of a type suitable for the required

load in compliance with the current electrical regulations.

The switch must not break the yellow and green earth cable at any point.

This operation must be performed by a qualified electrician.

The power supply cable must be easily accessible after installing the

machine.

Should the appliance power supply cable need to be replaced, this must

be carried out by a Service Centre.

Installation

P1118

192998241 gb.qxd 9/4/2008 10:07 AM Page 45

Downloaded From WashingMachine-Manual.com Manuals

1 2 ... 40 41 42 43 44 45 46 47 48

No comments

AEG LAVAMAT 62840 User Manual Page 45