AEG LAVAMAT 62840 User Manual download pdf (Page 44)

3. Set the hose correctly by loosening the ring nut.

After positioning the inlet hose, be sure to tighten

the ring nut again to prevent leaks.

4. Connect the hose to a tap with a 3/4” thread.

Always use the hose supplied with the appliance.

Installation should comply with local water authority

and building regulations requirements. A minimum

water pressure of 0.05 MPa is required for safe

operation of the appliance.

If you cannot make the cold water connection direct from the rising mains, you

may be able to operate the appliance from your cold water storage system. There

should be a minimum distance of between the appliance’s inlet and the bottom of

the water storage tank.

Water drainage

The end of the drain hose can be positioned in three ways:

Hooked over the edge of a sink using the plastic hose guide supplied

with the machine.

In this case, make sure the end cannot come

unhooked when the machine is emptying.

This could be done by tying it to the tap with a piece

of string or attaching it to the wall.

In a sink drain pipe branch. This branch must be

above the trap so that the bend is at least 60 cm above

the ground.

Directly into a drain pipe at a height of not less than 60 cm and not more

than 90 cm.

The end of the drain hose must always be ventilated, i.e. the inside diameter of

the drain pipe must be larger than the outside diameter of the drain hose.

The drain hose must not be kinked.

Installation

192998241 gb.qxd 9/4/2008 10:07 AM Page 44

Downloaded From WashingMachine-Manual.com Manuals

1 2 ... 39 40 41 42 43 44 45 46 47 48

No comments

AEG LAVAMAT 62840 User Manual Page 44