AEG LAV1571TurboS User Manual download pdf (Page 27)

If you intend the drain hose from the machine

to empty into a sink, make sure that the sink

is empty and the plug hole is not blocked. Use

the plastic “U -Piece” supplied.

Important

Before connecting up the machine to new

pipework or to pipework that has not been used

for some time, run off a reasonable amount of

water to flush out any debris that may have collected in the pipes.

In the interest of the environment

Washing machines and dish-

washers should be connected

to the FOUL drainage system,

the water will then be taken

to a sewage works for treat-

ment before being discharged

safely into a river.

It is essential that these appli-

ances are not connected to the

surface water drainage system

as this water is discharged

directly into a river or stream

and may cause pollution.

If you require any further

advice please contact your local

authority drainage department.

Water inlet (cold water connection only)

Before connect-

ing the hose be

sure to fit the

mesh filter «A»

supplied as per

diagram.

Installation

should comply

with local water

authority and building regulations’ requirements.

Set the hose correctly by loosening the ring nut. After positioning the

inlet hose, be sure to tighten the ring nut again to prevent leaks.

Do not connect to a hot water supply.

Water drainage

The appliance drain hose should hook into a standpipe, the hook in the

drain hose is formed using the plastic “U-Piece” supplied. The standpipe

should have an internal diameter of approximately 38 mm (see dia-

gram) thus ensuring there is an air break between the drain hose and

standpipe.

When discharging into a stand-

pipe ensure that the top of the

curve in the hose end is no

more than 90 cm (35.4”) and

no less than 60 cm (23.6”)

above floor level.

The upright standpipe should have a mini-

mum length of 30 cm (12”) from the bottom

of the elbow to the top of the pipe (see dia-

gram). Make sure that it is designed in such a

way that the end of the drain hose cannot be

covered with water.

Longer drain hoses are available in lengths

of 2.7 and 4 metres from your AEG Service

Force Centre.

Installation

SHOWER

BATH

SINK

TOILET

BIDET

WASHING

MACHINE

DISHWASHER

RAINWATER

'RUN-OFF'

SURFACE WATER

DRAINS & SEWERS

UNTREATED

DISCHARGE

RIVER

FOUL DRAIN

FOUL SEWERS

SEWAGE

TREATMENT

WORKS

RIVER

TREATED

DISCHARGE

RAINWATER

'RUN-OFF'

SURFACE WATER

DRAINS & SEWERS

Installation

3 pin

Max. 90 cm.(35.4")

Min.60 cm.(23.6")

Min. 30 cm.(12")

38 mm.(1/ ") diameter

standpipe

1 2 ... 22 23 24 25 26 27 28 29

Comments to this Manuals

No comments

AEG LAV1571TurboS User Manual Page 27

Comments to this Manuals

Related products and manuals for Washing machines AEG LAV1571TurboS