AEG LAV1571TurboS User Manual Page 19

  • Download
  • Add to my manuals
  • Print
  • Page
    / 29
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 18
Emergency emptying out
If the water is not discharged (pump is blocked, filter or drain hose are
clogged), proceed as follows to empty out the machine:
• pull out the plug from the power socket;
• close the water tap;
• if necessary, wait until the water has cooled;
• place a bowl on the floor;
• put the drain hose end into the bowl and let the water out.
Should it not be possible to have access to the drain hose because, for
example the appliance is built in the kitchen furniture, slightly loosen
the drain filter after placing a bowl on the floor to let the water come
out slowly.
At the end screw the filter again.
Frost precautions
If the machine is installed in a place where the temperature could drop
below 0°C, proceed as follows:
• Close the water tap and unscrew the water inlet hose from the tap.
Place the end of the drain hose and the inlet hose in a bowl placed
on the floor.
Select the “PUMP OUT” programme and run it until the machine
stops.
Turn the programme selector dial to RESET.
• Press the ON/OFF button to switch the machine off.
• Remove the plug from the power socket.
• Screw the water inlet hose back on and put the drain hose back in its
place.
By doing this, any water remaining in the machine is removed, avoiding
the formation of ice and, consequently, damage to the appliance.
When you use the machine again, make sure that the ambient temper-
ature is above 0°C.
37
Drain filter
The drain filter
collects threads
and small objects
inadvertently left
in the laundry.
Check regularly
that the filter is
clean.
Open the filter
door.
Place a container
under the filter
and unscrew it;
some water will
come out of the
filter.
Pull out the filter.
Clean the filter
under a running
tap, then refit it, screwing it fully in.
Water inlet filter
If you notice that the machine is taking
longer to fill, check that the filter in the
water inlet hose is not blocked.
Turn off the water tap.
Unscrew the hose from the tap and remove
the filter.
Clean it with a stiff brush.
Refit the filter and screw the hose back onto
the tap.
36
Cleaning and maintenanceCleaning and maintenance
Page view 18
1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 28 29

Comments to this Manuals

No comments