AEG L7FE7461BI User Manual

USER MANUALEN User ManualWashing MachineL7FE7461BI

The inlet hose1. Remove the inlet hose from inside thedrum.2. To connect the water inlet hose towardsthe proper direction and with the properinclinati

Ø 40 mmTo a stand pipe with vent-holeDirectly into a drain pipe at a height of notless than 60 cm (23.6”) and not more than 100cm (39.3”).The end of t

553 mm596 mm140 mm76 mm50 mm50 mm819 mmIf hoses run behind theappliance, make sure thatnothing closes the smallrecess indicated with themeasures 50 x

1. Remove the screws of the top cover on therear of the appliance and install the anti-tilting device as shown in the drawing.~10mm2. Adjust the anti-

Reversibility of the cupboard doorCarry out the cupboard door reversibilitybefore the appliance is built in completely.MNOIf the cupboard door has to

16-22 mm22±1,5 mm449mm595-598 mmØ 35 mm12,5 - 14 mmSet the position of the lower hole respectingdimensions and distances shown in thedrawing (449 mm).

2N1EDCCounter-magnetThe appliance is pre set for a magneticclosure.For a correct closure:1. Position the screw C and the counter-magnet D on the magne

5. CONTROL PANEL5.1 Control panel descriptionStart/Pause90°60°40°30°20°ColdNight14001200800DelayStartTime SaveCottonsSyntheticsDelicatesAnti-allergySt

Delay start indicator.The digital indicator can show:• Reset position ( ).• Programme duration (e. g. ).• Delay time (e. g. ).• Cycle end ( ).• Warn

dashes to indicate that no programmewas selected.6.4 Temp. When you select a washing programme,the appliance automatically proposes adefault temperatu

CONTENTS1. SAFETY INFORMATION...32. SAFETY INSTRUCTIONS...

6.8 Permanent Soft Plus Set this option to optimise the fabricsoftener distribution and improve fabricsoftness.Recommended when you use fabricsoftener

suitable for a full load of normallysoiled garments. a quick cycle for a full load of lightlysoiled garments. very quick cycle for a smaller lightlys

ProgrammeDefault tem-peratureTemperaturerangeReferencespin speedMaxi-mumloadProgramme description(Type of load and soil level)Cottons Eco1)40 °C60 °C

ProgrammeDefault tem-peratureTemperaturerangeReferencespin speedMaxi-mumloadProgramme description(Type of load and soil level)Steam-1 kg Cottons, Synt

ProgrammeDefault tem-peratureTemperaturerangeReferencespin speedMaxi-mumloadProgramme description(Type of load and soil level)Outdoor30 °C40 °C - Cold

ProgrammeDefault tem-peratureTemperaturerangeReferencespin speedMaxi-mumloadProgramme description(Type of load and soil level)Wool/Silk40 °C40 °C - Co

ProgrammeSpinNoSpinPrewash1) 2)Soft PlusPlus Steam2)Delay StartTime SaveSport Outdoor Denim

9. BEFORE FIRST USE1. Make sure that the electrical power isavailable and the water tap is open.2. Pour 2 litres of water into thedetergent compartmen

- Maximum level for quantity of liq-uid additives. - Flap for powder or liquid deter-gent.Always follow theinstructions that you find onthe packaging

display and the given informationchanges accordingly.If a selection is not possiblean acoustic signal soundsand the display shows.10.6 Starting a prog

1. SAFETY INFORMATIONBefore the installation and use of the appliance,carefully read the supplied instructions. Themanufacturer is not responsible f

2. Press the button On/Off again toactivate the appliance.If the ProSense System hascompleted and the waterfilling has already started,the new program

3. When the programme is completedand the door locked indicator goes off, you can open the door.4. Press the On/Off button for a fewseconds to deactiv

bleach for whites and laundrysanitization– liquid detergents, preferably forlow temperature washprogrammes (60 °C max) for alltypes of fabric, or spec

12.4 Door seal with double liptrapThis appliance is designed with a selfcleaning draining system, allowing lightfluff fibers that fall off the clothes

3. Make sure that all detergent residueis removed from the upper and lowerpart of the recess. Use a small brushto clean the recess.4. Insert the deter

121. Open the pump cover.2. Place a suitable bowl below the drain pumpaccess to collect the water that flows out.Always keep a rag nearby to dry up an

7. If it is necessary, remove fluff and objectsfrom the filter recess.Make sure that the impeller of the pump canrotate. If it does not rotate, contac

12.8 Cleaning the inlet hose and the valve filter12345°20°12.9 Emergency drainIf the appliance cannot drain the water,carry out the same procedure, de

13.1 IntroductionThe appliance does not start or it stops during operation.First try to find a solution to the problem (refer to the table). If the pr

13.2 Possible failuresProblem Possible solutionThe programme doesnot start.• Make sure that the mains plug is connected to the mainssocket.• Make sure

– by clients in hotels, motels, bed & breakfast andother residential type environments;– areas for communal use in blocks of flats or inlaunderett

Problem Possible solutionYou cannot open the ap-pliance door.• Make sure that a washing programme that ends with waterin tub, has been selected.• Make

CAUTION!Risk of burns! Make surethat the watertemperature is not toohigh and the laundry is nothot. If necessary, wait untilthey cool down.CAUTION!Ris

Programmes Load(kg)Energyconsump-tion (kWh)Waterconsump-tion (litre)Approxi-mate pro-grammeduration(minutes)Remain-ing mois-ture (%)1)Delicates40°C2 0

Spin Speed Maximum spin speed 1351 rpm1) The appliance works correctly if the water pressure is not lower than 0.05 MPa (0.5 bar). If you cannotconnec

The 'standard 60 °C cotton programme' and the 'stand-ard 40 °C cotton programme' are the standard washingprogrammes to which the i

ENGLISH 45

www.aeg.com46

ENGLISH 47

www.aeg.com/shop157020290-B-242018

• The floor area on which the applianceis to be installed must be flat, stable,heat resistant and clean.• Make sure that there is air circulationbetwe

2.5 Service• To repair the appliance contact anAuthorised Service Centre.• Use original spare parts only.2.6 DisposalWARNING!Risk of injury or suffoca

1. Put two polystyrene packagingelements on the floor under theappliance.WARNING!It is stronglyrecommended that thisaction is carries out by twoperson

6. Remove the three bolts, the hoseholders and plastic spacers by using thespanner supplied with the appliance.FG7. Close the holes with the plastic c

3.5 Positioning and levellingx41. Install the appliance on a flat hard floor.WARNING!Make sure that carpets do notstop the air circulation belowthe ap