AEG L75480WD User Manual download pdf (Page 22)

9.13 NON-STOP programme -

Washing & Timed Drying

CAUTION!

Do not put a plastic device/ball

for the detergent into the

drum.

•

Press button

1

to activate the appli-

ance.

• Load the laundry.

• Measure out the detergent and the

fabric conditioner.

• Turn the programme dial to the wash-

ing programme. The display shows the

wash symbols.

Do not set a spin speed lower than

the automatic speed of the set pro-

gramme.

• Set the available options.

•

Press the button

7

to set the drying

time value. The display shows a mini-

mum time value.

The drying symbol

comes on.

Set drying time value

• After some seconds the display shows

the total duration of the cycles.

Final time value (washing

+ drying + anti-crease +

cooling phases)

If you set a drying time of only 10

minutes, the final time value in-

cludes also the anti-crease and

the cooling phases.

• Press button 4 to start the pro-

gramme.

The door is locked

The display shows the new time value

each minute.

• When the programme is completed,

the appliance stops automatically.

• The acoustic signals operate.

•

When the door locked symbol

goes off, you can open the door.

• Remove the laundry from the appli-

ance. Make sure that the drum is emp-

ty.

• Close the water tap.

• Keep the door ajar, to prevent mildew

and odours.

9.14 Fluff in the fabrics

During the washing and/or drying phase,

some types of fabric, (sponge, wool,

sweatshirt) could release fluff.

The released fluff could stick to the fab-

rics during the next cycle.

This inconvenient increases with techni-

cal fabrics.

To prevent the fluff in your laundry, we

recommend that you:

• To do not wash dark fabrics after you

washed and dried light coloured fab-

rics (new sponge, wool, sweatshirt )

and the contrary.

• To dry this type of fabrics at open air

when they are washed the first time.

• To clean the drain filter.

• After the drying phase, clean the emp-

ty drum, the gasket and the door with

a wet cloth.

To remove the fluff inside the drum,

set a special programme:

• Empty the drum.

• Clean the drum, the gasket and the

door with a wet cloth.

• Set the rinse programme.

•

Press at the same time button

9

and

button

7

to activate the cleaning

function until the display shows CLE.

•

Press button

4

to start the pro-

gramme.

22

www.aeg.com

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 39 40

Comments to this Manuals

No comments