AEG KS8404021M User Manual download pdf (Page 42)

The side lamp

1. Remove the left shelf support to get

access to the lamp.

2. Use a Torx 20 screwdriver to remove

the cover.

3. Remove and clean the metal frame

and the seal.

4. Replace the lamp with a suitable 300

°C heat-resistant lamp.

5. Install the metal frame and the seal.

Tighten the screws.

6. Install the left shelf support.

13. TROUBLESHOOTING

WARNING!

Refer to Safety chapters.

13.1 What to do if...

Problem Possible cause Remedy

The oven does not heat up. The oven is deactivated. Activate the oven.

The oven does not heat up. The clock is not set. Set the clock.

The oven does not heat up. The necessary settings are

not set.

Make sure that the settings

are correct.

The oven does not heat up. The automatic switch-off is

activated.

Refer to "Automatic switch-

off".

The oven does not heat up. The Child Lock is on. Refer to "Using the Child

Lock".

The oven does not heat up. The door is not closed cor-

rectly.

Fully close the door.

The oven does not heat up. The fuse is released. Make sure that the fuse is

the cause of the malfunction.

If the fuse releases again

and again, contact a quali-

fied electrician.

The lamp does not operate. The lamp is defective. Replace the lamp.

The display shows F111. The plug of the core tem-

perature sensor is not cor-

rectly installed into the sock-

et.

Put the plug of the core tem-

perature sensor as far as

possible into the socket.

www.aeg.com42

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 48

Comments to this Manuals

No comments

AEG KS8404021M User Manual Page 42

Comments to this Manuals

Related products and manuals for Unknown AEG KS8404021M