AEG 600 KVA User's Guide download pdf (Page 23)

23UPS 20-30 kVA, 230 V 50/60 Hz output

User’s Guide

1026743

Revision B

Connection to the standard RS-232 port (X53)

The standard RS-232 interface uses 9-pin female D-sub connector. It shall be used with the

delivered cable for a computer or external modem connection. The data is transmitted with XCP

protocol that includes status and meters information about the UPS. The RS-232 port has the

following format:

Communication speed 19200 bps*

Data bits 8

Parity None

Stop bits 1

Handshake None

*Communication speed can be changed via LCD menu

Figure 10 Identiﬁcation of the interface port pins.

LanSafe software

LanSafe software shuts down computers and whole networks in case of an extended power

failure. It provides basic monitoring, data logging, notification and event actions for a single

UPS solution. The software is bundled free of charge in Software Suite CD.

The connection procedure for the RS-232 interface port is following:

1. Connect the RS-232 communication cable to the computer.

2. Connect the RS-232 communication cable to the serial interface on the UPS.

3. Run the UPS software installation disk (Software Suite CD) on the computer.

Note!

If communication does not work choose the correct bit rate from the LCD display.

Please refer to the optional software documentation for appropriate bit rate settings.

•

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 51 52

No comments

AEG 600 KVA User's Guide Page 23