Aeg WSP 7010 User Manual Page 16

  • Download
  • Add to my manuals
  • Print
  • Page
    / 19
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 15
For the Fitter
2.6 First-time Operation
2.6.1 Function Test
Check the function of the fan for the storage unit by switching on the room temperature
regulator.
2.6.2 Charging
The units can be started without initial heating up after the function test. Charging takes place
either manually with the adjuster of the mechanical charging control unit or automatically with
the available Elfamatic charging control unit.
During initial charging, the charging in kWh must be determined and compared with the
maximum permissible charging from the cold state specified in the "Technical Data". The
determined charging may not exceed the maximum permissible charging from the cold state.
During initial charging, a smell may be produced, the room should therefore be adequately aired
Xl\ {1.5 times air change, e.g. tilted windows). Initial charging in the bedroom should not take place
/ • \ when sleeping in it if possible.
2.7 Repair, Conversion of Unit
Proceed according to these installation instructions as for the initial installation for re-installation
of a unit which has been dismantled for repairs or which was in operation somewhere else.
In these cases the following must be paid special attention: Parts of the thermal insulation at
which there are visible signs or damage or change which could impair the safety must be replaced
by new parts. The insulation must be tested and the rated consumption measured before commis
sioning.
2.7.1 Conversion of the Unit
The instructions enclosed with the respective fitting set are applicable for conversions, additions
and installations.
2.8 Transfer
Explain the functions of the unit to the user. Draw his attention to the safety instructions in
particular.
Hand over the operating and installation instructions to the user.
O)
lS
AEG
WSP 7010
357 kg
E-No. 956 042 710 F-No, 2(^200504
-E№
1/N/PE AC 230V 50Hz
a
1,5 kW
A
26 W
-
C € Made in Germany
Symbols of the rating plate
(Example WSP 7010)
Q Total weight
) Charging
Discharging
-EMT Supplementary heater
A fan
31
Page view 15
1 2 ... 11 12 13 14 15 16 17 18 19

Comments to this Manuals

No comments