Aeg HG795440XB User Manual download pdf (Page 12)

ones which are necessary for the

type of gas you use (see table in

"Technical Information" chapter).

4.

Assemble the parts, follow the same

procedure backwards.

5.

Replace the rating plate (it is near

the gas supply pipe) with the one for

the new type of gas supply. You can

find this plate in the package sup-

plied with the appliance.

If the supply gas pressure is changeable

or different from the necessary pressure,

you must fit an applicable pressure ad-

juster on the gas supply pipe.

8.4 Adjustment of minimum

level

To adjust the minimum level of the burn-

ers:

1.

Light the burner.

2.

Turn the knob on the minimum posi-

tion.

3.

Remove the knob.

4.

With a thin screwdriver, adjust the

by-pass screw position.

A

A)

The by-pass screw

• If you change from natural gas G20 20

mbar to liquid gas, fully tighten the

adjustment screw in.

• If you change from liquid gas to natu-

ral gas G20 20 mbar, undo the by-pass

screw approximately 1/4 of a turn.

WARNING!

Make sure the flame does not go

out when you quickly turn the

knob from the maximum position

to the minimum position.

8.5 Electrical connection

• Do not pull the mains cable to discon-

nect the appliance. Always pull the

mains plug.

• The appliance must not be connected

with an extension cable, an adapter or

a multiple socket. There is a risk of fire.

• Do not let the power cable to heat up

to a temperature of more than 90° C.

The cable should be guided by means

of clamps fixed to the side of the cabi-

net, in order to avoid any contact with

the equipment beneath the cooktop.

• Make sure that there is access to the

mains plug after the installation.

Electrical Requirements

Permanent electrical installation must

agree with the latest I.E.E. Regulations

and local Electricity Board regulations.

For your own safety the installation must

be done by a qualified electrician (e.g.

your local Electricity Board, or a contrac-

tor who is on the roll of the National In-

spection Council for Electrical Installa-

tion Contracting [NICEIC]).

The manufacturer refuses to be

held responsible, if these safe-

ty measures are not abided by.

Supply connections:

This hob has to be connected to 230 —

240 V ( 50 Hz) electricity supply.

The hob has a terminal block which is

marked as follows:

• L — Live terminal

• N — Neutral terminal

•

or E — Earth terminal

Before carrying out the connection,

make sure:

1.

The limiter valve and the electrical

system can take the appliance load

(see the rating plate)

2.

The supply system is equipped with

an efficient earth connection in com-

pliance with the current standards

and regulations

3.

The outlet or omnipolar switch used

for connection is easily accessible

with the appliance installed.

The appliance is supplied with a 3 core

flexible powercable with a 3 amp plug. If

it is necessary to change the fuse, use a

3 amp ASTA-approved (BS 1362) fuse.

12

www.aeg.com

1 2 ... 7 8 9 10 11 12 13 14 15 16

Comments to this Manuals

No comments