Aeg 155 D User Manual Page 1

155 DDunstabzugshaube Cooker hood Hotte aspirante Cappa aspiranteMontage- und Gebrauchsanweisung Installation and Operating Instructions Instructions

Safety Never leave a cooking hob or ring on without a pot or pan on top warnings of it, to avoid the possibility of excess heat damaging the unit. Ga

Hood OperationThe control panel is located on the front of the hood.The control panel numbers and symbols (Fig. 7 from left to right) are explained in

Setting the fan speed (Fig- 8)Press the ([^) button (F) to select the fan speed from 1 to 9, keeping it pressed until the speed you want,

Intensive speed P (Fig. 9)To select the intensive speed (P), press the increase speed button ([^) (F) until the letter P (high speed) is shown on the

Switching off the fan (Figures 10-11)34Press the key (B) to switch off the fan at any speed including P.After 5 seconds the number “0”

The hood should always be switched on before you start cooking and left on for approximately 15 minutes after you have finished (fan timerThe activ

Proceed as follows to remove and change my activated carbon filter:Switch of the fan motor by pressing the button.Take the precaution of

2. The activated carbon filter should under absolutely no circumstances ever be washed. To remove it, press the two red buttons B and pull

Display warning on saturation of metal grease filter (Fig. 15)After 30 operating hours the letter (F- grease filters) will flash on and off on the dis

2. Clean the inner housing using a hot detergent solution only (never use caustic detergents, abrasive powders or brushes).3. Leave the meta

ContentsIntroduction... 23Extractor version...

Changing — Disconnect the unit from the mains power supply, the light — Remove my coverbulbs — Replace the old light bulb with a new light bulb (40 W

MKZ telescopic wall pipe 120 mm outlet hose KLF60/80 activated carbon filterE-Nr. 610 899 004 610 899 007 610 899 421Technical assistance serviceY

AEGBitte geben Sie unserem Kundendienst folgende Angaben bei einer Störung an:If your appliance has a fault, please contact our service engineer and s

IntroductionThe hood is supplied as an extractor unit and can also be used with a filtering function by fitting activated carbon filt

FilterversionThe air is filtered and recirculated through the front grille.You will need an original AEG KLF60/80 activated carbon filter for filterin

Electrical connectionsCheck that the power supply voltage shown on the rating plate Safety corresponds to the mains supply before proceeding to make a

SpecificationsDimensions:Height152Weight:Net:Gross:Width599Depth (in mm) 50510.5 Kg11.5 KgMaximum absorbed power: 360 W Motor absorption: 2 x 140 W Li

MontageWhen used as an extractor unit, the hood must be fitted with a 120mm diameter hose.If the outlet hose is installed In a hori

Since the rule for rooms with fuel burning appliances is “outlet hole of the same size as the ventilation hole”, a hole of 500-600 cm^, which

Drill four holes in the base of the wall unit using the template Wall unit supplied. mountingMount the hood unit on the base of the wal