AEG F34502VI0 User Manual download pdf (Page 15)

Problem Possible solution

The anti-flood device is on. Close the water tap and contact the Service.

After the checks are completed, activate

the appliance. The programme contin-

ues from the point of interruption.

If the problem occurs again, contact the

Service.

If other alarm codes appear, contact the

Service.

10.1 If the washing and drying

results are not satisfactory

Whitish streaks or bluish layers on

glasses and dishes

• The released quantity of rinse aid is

too much. Adjust the rinse aid selector

to a lower position.

• The quantity of detergent is too much.

Stains and dry water drops on glasses

and dishes

• The released quantity of rinse aid is

not sufficient. Adjust the rinse aid se-

lector to a higher position.

• The quality of the detergent can be

the cause.

Dishes are wet

• The programme is without a drying

phase or with a low temperature dry-

ing phase.

• The rinse aid dispenser is empty.

• The quality of the rinse aid can be the

cause.

Refer to ‘HINTS AND TIPS’ for

other possible causes.

11. TECHNICAL INFORMATION

Dimensions Width / Height / Depth

(mm)

596 / 818 -898 / 555

Electrical connection Refer to the rating plate.

Voltage 220 - 240 V

Frequency 50 Hz

Water supply pressure Min. / max. (bar / MPa) (0.5 / 0.05 ) / (8 / 0.8 )

Water supply

Cold water or hot water

max. 60 °C

Capacity Place settings 12

Power consumption Left-on mode 0.50 W

Off-mode 0.50 W

Connect the water inlet hose to a water tap with a 3/4'' thread.

If the hot water comes from alternative sources of energy, (e.g. solar panels, aeolian

energy), use the hot water supply to decrease energy consumption.

ENGLISH 15

1 2 ... 10 11 12 13 14 15 16 17 18 19 20

Comments to this Manuals

No comments

AEG F34502VI0 User Manual Page 15

Comments to this Manuals

Related products and manuals for Dishwashers AEG F34502VI0