AEG DD8694-M User Manual download pdf (Page 7)

INSTALLATION

Wall drilling and bracket fixing

Wall marking:

• Drawaverticallineonthesupportingwalluptotheceiling,orashighaspractical,atthe

centre of the area in which the hood will be installed.

• Drawahorizontallineat450mmabovethehob.

• Placebracket7.2.1 on the wall as shown about 1-2 mm from the ceiling or upper limit align-

ing the centre (notch) with the vertical reference line.

• Markthewallatthecentresoftheholesinthebracket.

• Placebracket7.2.1 on the wall as shown at X mm below the first bracket (X = height of the

upper chimney section supplied), aligning the centre (notch) with the vertical line.

• Markthewallatthecentresoftheholesinthebracket.

• Markareferencepointasindicatedat116mmfromtheverticalreferencelineand590mm

abovethehorizontalreferenceline.

• Repeatthisoperationontheotherside.

• Drillø8mmholesatallthecentrepointsmarked.

• Insertthewallplugs11intheholes.

• Fixthelowerbracket7.2.1 using the 12a screws (4,2 x 44,4) supplied.

• Fixtheupperbracket7.2.1 and the air outlet connection support 7.3 together using the 2

screws 12a (4,2 x 44,4) supplied.

• Insertthetwoscrews12a (4,2 x 44,4) supplied in the hood body fixing holes, leaving a gap of

5-6 mm between the wall and the head of the screw.





















1 2 3 4 5 6 7 8 ... 68

No comments

AEG DD8694-M User Manual Page 7