Aeg AR 4021 BT User Manual download pdf (Page 83)

ENGLISH

3. The connection of “Continuous +” (continuous cur-

rent connection) may dier depending on the vehicle

type. (However, this is required for storing of the radio

stations.)

In order to assure all functions, installation according

to these instructions is necessary. In case of doubt,

please contact an authorized car workshop.

Because of the dierent vehicle types and vehicle

manufacturers, correct wiring of the ISO connector

is no assured even when the ISO plug connectors t

mechanically. Thus it may be necessary to change the

electric connection or to use a vehicle-specic adap-

tor.

NOTE

In case of correct connection, the radio can be

►

switched on and o with the ignition. In case of

possible loss of stored radio stations, the radio is

not provided with the “Continuous +” required

for station storage.

CAUTION

In case of connection to “Continuous +” without

►

ignition, an unnecessary load may be caused for

the car battery even when the radio is switched

o. In the worst case, this may lead to discharge

of the car battery.

4. Depending on the vehicle type, interferences may

occur during operation of the radio. These can be

eliminated with an additional noise lter. Your set is

already equipped with a noise lter as standard. In

spite of this, interferences may be caused depending

on the vehicle.

Noise lters are available from car accessory sellers

and/or your car workshop.

5. When installing your radio, take care that there is

sucient free space at the rear of the radio to assure

sucient cooling.

6. There are two dierent standards for the antenna

connection. The rst one is the old one (50 Ohm) with

a long projecting round contact on the vehicle side

and a round socket on the radio side. The second one

is the ISO standard antenna plug (150 Ohm). Adapters

for both formats are oered by car accessory sellers

and/or your car workshop.

NOTE

To be strictly observed for VW/Audi: The antenna

►

of your vehicle may be an active antenna. This

requires a voltage supply only provided by the

original car radios. If this should be the case,

please use an antenna adapter for phantom feed.

Antenna adapters are available from car acces-

sory sellers and/or your car workshop.

Mounting Instruction

The correct tools are self-explanatory for a car hi



installation.

Insert the unit into the ISO slot or select a location



where you can reach all controls and the unit is not in

the diver’s way.

Connect only to a properly installed 12 V battery.



Connect only via the ISO connectors.



Install the unit in such way that no overheating is pos-



sible and the unit is well ventilated.

If the installation angle exceeds 30° the unit might not



perform well.

Avoid installing the unit where it is subjected to high



temperature, such as from direct sunlight, hot air from

the heating ducts, or where subjected to dust, dirt or

excessive vibration.

Contact your car manufacturer or the local dealer if



vehicle modications are necessary.

Installation in ISO Slot

Remove sleeve (D) and frame (B) from the unit. Use



installation keys (C), if necessary.

Place the sleeve in the ISO slot.



Bend the claws outward with a screwdriver for perfect



t.

Check the sleeve for tight t.



Connect the ISO female connectors of the unit with



the two ISO male connectors of the vehicle.

Connect the antenna to the antenna connector at the



rear of the unit.

Secure the unit against theft, if necessary. Attach bolt



and mounting strip with the fastening materials at the

rewall.

1 2 ... 78 79 80 81 82 83 84 85 86 87 88 ... 113 114

Comments to this Manuals

No comments

Aeg AR 4021 BT User Manual Page 83

Comments to this Manuals

Related products and manuals for Audio Aeg AR 4021 BT