AEG T75175AV User Manual download pdf (Page 19)

If the hose is long and the

room temperature low, the

moisture might condense to

water inside the hose. This is

an usual occurrence. To

prevent this water from the

hose, it is recommend to

drill a small hole (via. 3 mm)

in the lowest point of the

hose and to put a small

container below it. (See

picture, point B).

Installation

There are 3 vent outlets: on

the left, right side and at the

rear.

1. Pull the ring nut A from the vent

outlet at the rear.

2. Screw on the ring nut to the hose

and push it into position.

The not used vents must be sealed

with supplied covers.

15.3 Load door reversal

WARNING!

Before changing the door

stop, disconnect the mains

plug.

Note regarding contact

protection: The appliance is

only secure for operations

again once all plastic parts

have been put.

1. Open load door.

2. Unscrew hinge A from the front of

the appliance and remove the load

door.

3. Remove cover plates B. To do this,

put a thin screwdriver into the slots

as shown in the illustration, push

down lightly and remove the cover

plates.

ENGLISH

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 43 44

No comments

AEG T75175AV User Manual Page 19