AEG LAV88830-W User Manual download pdf (Page 24)

Operating Instructions

Start the washing program

0 1. Check that the water valve is open.

2. Start the washing program: Press the button O/s

(START/PAUSE). The washing program is started or it

starts after the set time expires.

/W (DOOR/LIGHT) flashes red when the button O/s (START/

PAUSE) is pressed, the door is not properly closed. Press the door firmly

closed and press the button O/s (START/PAUSE) again.

If the time preselection is set:

The set time delay runs. The remaining time until the program start is

shown in the Multidisplay (always in full hours). During this time you

can load washing or change / abort the time preselection.

• Load washing: Press the button O/s (START/PAUSE). The door can

be opened. Then close the door and again press the button O/s

(START/PAUSE).

• Change or abort time preselection: Press the button b (DELAY TI-

MER) as often as necessary until the required time is displayed; When

the program duration is displayed (shown in minutes, e. g. 125), the

washing program starts without a delay.

While the time delay is running, the washing machine switches to

Stand-by mode. Only X (DURATION) is illuminated from behind. The

multidisplay shows the remaining time until the program start. All

other displays on the control panel are switched off in order to save en-

ergy. Pressing any arbitrary button cancels the stand-by mode.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 59 60

No comments

AEG LAV88830-W User Manual Page 24